DDL-9000C-S Multi-layered section detection sensor (asm.)
INSTRUCTION MANUAL
CONTENTS |
|
Function.......................................................................................................................... |
1 |
Description of parts supplied with the device............................................................. |
1 |
Version of sewing machine software............................................................................ |
2 |
How to install the multi-layered section detection sensor |
|
to the sewing machine................................................................................................... |
4 |
How to operate the operation panel............................................................................. |
7 |
i
Congratulations on your purchase of a part for the JUKI industrial sewing machines.
Be sure to read "Safety precautions" and the Instruction Manual for the sewing machine for which the purchased part is to be used, carefully before putting the purchased part into use.
Function
This is the device intended to be fitted to the DDL-9000C-S (digital type).
Sewing parameters can be automatically changed over appropriately at multi-layered sections of material by fitting the multi-layered section detection sensor to the sewing machine.
The multi-layered section detection setting can be stored in memory on a pattern-by-pattern basis.
Sewing parameters that can be changed over |
S003 |
: Pitch |
|
S047 |
: Sewing speed |
|
S048 |
: Feed locus |
|
S050 |
: Feed dog height |
Detectable material thickness |
Max. 10 mm |
|
Detection resolution |
0.1 mm |
|
*Multi-layered section of material that is less than 2 mm in thickness is likely to be affected by the feed dog height. Stable detection, therefore, cannot be carried out. It is not possible to detect two or more multi-lay- ered sections thickness of which are different. In this case, the one-touch changeover function by means of the hand switch should be used.
*The multi-layered section detection function is disabled while the one-touch changeover function by means of the hand switch is carried out.
Description of parts supplied with the device
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
No. |
Part number |
Part name |
Qty |
|
23610108 |
Presser bar holder |
1 |
|
40188614 |
Multi-layered section sensor magnet base (asm.) |
1 |
|
SS7112420SP |
Clamping screw of presser bar holder |
1 |
|
SS7091810SP |
Setscrew of multi-layered section sensor magnet base (asm.) |
1 |
|
40188623 |
Multi-layered section sensor (asm.) |
1 |
|
SM4040655SP |
Setscrew of multi-layered section sensor (asm.) |
2 |
|
40139753 |
Cord fixture |
1 |
|
40188624 |
Instruction manual |
1 |
– 1 –
Loading...