www.dexpress.com DIMENSION EXPRESS Fax on Demand (775) 833-3600
|
This Data Sheet Includes Information On |
||
|
Jenn-Air |
|
|
• |
Product Model Number (s): |
|
• |
|
30" Undercounter or Wall Ovens: |
|
|
|
W30400S, W30400B and W30400W |
||
• |
Dimensions (Actual Size) |
|
• |
|
Cutout width: |
28 |
3/16" |
|
Cutout height: |
27 |
7/16" |
|
Minimum cabinet width: |
30" |
|
|
Minimum cabinet depth: |
23 |
1/2" |
Recommended cutout location from floor : 4" to 33"
Distance from face of cabinet to
outer edge of open door (Door swing): 20 1/2"
Distance from face of cabinet to
front of closed door handle: 2 5/8"
Overall unit width: 29 3/4"
Overall unit height: 27 3/4"
Penetration into cabinet: 23 7/16"
Oven overlap distances when using cutout dimensions listed above:
Top overlap: 5/16"
Bottom overlap: 0"
Right side overlap: 3/4"
Left side overlap: 3/4"
• |
Additional Information |
• |
•Total connected load: 3.6KW, 15 amps @120/240v. 3 wire single phase, 60Hz.
•A complete floor is recommended to prevent unusual drafts and capable of supporting 142 lbs.
•Minimum distance from bottom of opening to any object protruding from cabinet face (i.e. cabinet door) directly below: 7/8" (because it is an air flow area)
SEE PAGE 2 FOR UNDERCOUNTER INSTALLATION
Subject to change without notice. This system is designed to |
|
be updated daily if necessary. Dimension Express is not |
|
responsible for use of superseded, voided, or outdated data |
|
sheets. Because of the difficulty or impracticability of deter- |
|
mining actual damages, liability of Dimension Express shall |
|
not exceed $50.00. |
|
Copyright © Dimension Express, 2000. |
214 |
Cabinet Opening
(not to scale)
Locate electrical box in this location. Provide a 1 1/4" conduit hole in the rear right hand side of the opening floor.
30"
|
28 3/16" |
|
|
|
|
|
|
|
|
|
|
23 1/2" |
|||||
|
|
|||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
27 7/16"
4" to 33"
Overall Dimensions
(not to scale)
27 3/4"
23 7/16" |
29 3/4" |
2 5/8"
• NEVER reuse Data Sheets. Data Sheets are subject to change without |
• Call Dimension Express if you have any questions at (775) 833-3633 • |
notice. Dimension Express is a FREE service bureau and is updated daily, |
• Always refer to a current Code at a Glance or manufacturer directory • |
it makes far more sense to spend the time necessary to request new Data |
• Data Sheet codes change on the first of odd numbered months at 12:01am • |
Sheets for each project, as opposed to the problems, time, costs, and risks |
BN205.05 • A214B149 • 31469 • 002906 • 173448 • 41382 |
associated with reusing old Data Sheets. |