Jaguar 2015 Ftype Owner's Manual

F-TYPE
Information Provided by:
QUICK START GUIDE
CONTENTS
Driver controls 2 Vehicle access 3 Comfort adjustments 4 Starting and driving 5 Driving aids 8 Heating and ventilation 10 Audio and Touch screen 11 Navigation 14 Telephone 15 Gas station information 16
Some features may not apply to your vehicle. Refer to the Owner’s Handbook for full operating instructions.
DRIVER CONTROLS VEHICLE ACCESS
Information Provided by:
1. Central locking/unlocking.
2. Seat adjustment.
3. Driving position memory.
4. Trip computer.
5. Turn signals and headlamp control.
6. Gearshift down.
7. Phone.
8. Instrument panel, Message center and warning
lamps.
9. Heated steering wheel.
10. Gearshift up.
11. Wiper/washers.
12. Home menu.
13. Climate menu.
14. Touch screen on/off or Parking aid.
15. Touch screen Setup or Rear camera.
16. Audio/video mode selection.
17. Phone menu.
18. Audio/video menu.
19. Navigation menu.
20. Climate control.
21. Power socket.
22. Gear selector.
23. Audio/video system on/off.
24. Active exhaust.
25. Convertible roof switch.
2
26. Intelligent stop/start.
27. Deployable rear spoiler switch.
28. Electric parking brake.
29. Stability control.
30. Driving mode.
31. STOP/START.
32. Heated rear screen.
33. Heated windshield.
34. Windshield maximum defrost.
35. Hazard warning lamps on/off.
36. Climate control recirculation.
37. Air conditioning on/off.
38. Climate control AUTO mode.
39. Cruise control or Automatic speed limiter.
40. Horn.
41. Steering wheel adjuster.
42. Audio/video mode selection.
43. Audio/video and phone controls.
44. Instrument illumination.
45. Fog lamps on/off.
46. Trunk/tailgate release.
47. Exterior mirror controls.
48. Window controls.
Note: Steering wheel design may differ.
Smart key
Information Provided by:
Press once to lock the vehicle and arm the alarm. To also close any open windows, press and hold for 3 seconds (Global closing). Multi-point entry - press once to disarm the alarm, unlock all of the doors and the trunk.
Single-point entry - press once to disarm the alarm and unlock the driver’s door. A second press unlocks the passenger door and the trunk.
Press and hold to open the windows (Global opening). The door handles will be presented for opening. To change between entry modes, with the vehicle
unlocked, press the lock and unlock buttons simultaneously for 3 seconds. The hazard warning lamps will flash twice to confirm the change.
Press once to switch the headlamps on for up to
120 seconds. Press again to switch off.
Press to open only the trunk/powered tailgate. The rest of the security system remains active.
Press and hold for 3 seconds to
activate/cancel the panic alarm.
Smart key detection
The Smart key may not be detected if it is placed in a metal container, or if it is shielded by a device with a back lit LCD screen, (e.g., laptop, smartphone, etc.).
Loose coins in the same pocket as the Smart key can also act as a shield. Keep the Smart key clear of possible shielding when attempting Keyless entry or Keyless starting.
Smart key not found
If the Smart key is not detected and the message Smart Key Not Found is displayed, hold it in the indicated position. Start the engine as normal. The Smart key can now be removed.
Keyless entry and locking
The door handles will operate only while the Smart key is within 3 ft (1m) of the vehicle.
To unlock the vehicle and disarm the alarm, press a door handle recess or trunk release button.
To lock - press the rear of the door handle until it is flush with the door. The doors and trunk will lock and the alarm will be activated. Doors can still be unlocked from inside the vehicle.
When locking, the convertible roof should be up.
Smart key detection
Do not leave your Smart key inside the trunk, the vehicle WILL NOT automatically unlock (should it become shielded).
Powered tailgate
See page 2, item 46
To open:
1. With transmission P selected, press the external
tailgate release.
2. Press the internal tailgate release.
Alternatively, use the Smart key. The powered tailgate will continue to open to the set
height.
To close:
3. Press and release.
If an obstruction is detected during closing, the tailgate will stop and then reverse direction slightly. An audible warning will indicate a mislock.
3
COMFORT ADJUSTMENTS
Information Provided by:
Setting the driving position
See page 2, items 2, 3, 41 and 48
Driver’s seat
Set the seat position using the following controls.
1. Seatback angle.
2. Lumbar support.
3. Memory preset buttons 1, 2 and 3.
4. Memory set button.
5. Seat forwards and backwards, cushion height and
cushion angle.
6. Side bolsters inflate and deflate.
7. With the vehicle stationary, adjust tilt and reach of the
steering wheel to your ideal driving position.
8. Press the left or right mirror selector. Use the mirror
adjuster to set the mirror positions.
Storing the driving position to memory
When the driver’s seat, steering wheel and door mirrors are adjusted to the required position, the settings can be stored.
Press the memory set button to activate the memory store function. The button will illuminate to indicate that the memory store function is active.
Within 5 seconds, press button 1, 2 or 3 to store the current driving position.
A stored memory position can now be recalled with a press of the appropriate button. The driver’s seat, steering wheel and mirrors will move to their preset positions.
Time limit
Memory buttons must be pressed within 5 seconds of pressing the memory set button, otherwise the memory store function will cancel.
Convertible roof
See page 2, item 25
To operate the convertible roof, the ignition must be on and road speed must be below 30 mph (50 km/h).
1. To open the roof, press and hold down the front of the switch.
2. A warning will sound, the windows will open and the roof will start to move. The warning will sound again when the roof is fully open.
3. Now release the switch. Closing is the reverse of this procedure. Pull up the front
of the switch until the roof is fully closed and latched.
4
Engine start/stop
Information Provided by:
See page 2, item 31
Ignition on:
With the Smart key inside the vehicle, press the
START/STOP button to switch on the ignition. A second press will switch off the ignition.
Engine start
The transmission must be in the P or N position.
With the brake pedal pressed, press and release the
START/STOP button to start the engine.
Engine stop
With transmission P selected and the EPB applied,
press to stop the engine and switch off the ignition.
Transmission
See page 2, item 22
1. Press the brake pedal before and while the selector is
moved from the P position.
2. The selector release button must be pressed when
moving from P or N.
3. Move the selector backwards to D or forwards to N or
forwards again to R. An LED on top of the selector will illuminate to indicate current gear selection.
4. To select S mode when in D, move the selector to the
left. The selector can now be moved forwards to mo ve up a gear and backwards to move down a gear. To return to fully automatic mode, move the selector back to D.
5. To select Park , simply press the P switch on top of
the selector. This can be done while in any gear selection. The vehicle must be stationary when P is selected.
If the engine is switched off with any other gear still selected, the transmission will automatically return to P.
Smart key use
The engine will continue to run, even if the Smart key is removed from the vehicle. However, if the engine is stopped, it cannot be restarted until the Smart key is returned to the vehicle.
Rolling start
If the engine is switched off while the vehicle is moving, it can be restarted after 2 seconds have elapsed. Select transmission N and then press the START/STOP button.
Towing the vehicle
If the engine is switched off with N selected, automatic selection of P is delayed for 10 minutes. This allows enough time for the vehicle to be conveyed through an automatic car wash. DO NOT use this feature to enable towing of the vehicle. Refer to Vehicle recovery in the Owner’s Handbook.
5
Loading...
+ 11 hidden pages