Hisense HL55K610PZLN3D, HL50K610PZLN3D User Manual

4.6 (7)
K610 Series
QUICK SETUP GUIDE
4
MAKING CONNECTIONS
TV Side View
HEADPHONE
CY-G130221
条形码定位框 35x10.5mm
物料号:1128289
VGA & AUDIO
Connect a VGA cable and an audio cable from the PC.
To select the VGA: Press [Source] button, when the list of In Source appears,
press [▲/▼] to select the source [VGA], then press [OK] to connect.
ACCESSORIES LIST1
User Manual
Remote Control
For HL50K610
For HL55K610
If the item is not specif ied in the accessories list, it should be provided by customer.
Recommend the active shutter 3D glasses model FPS3D07A. Other brands 3D
PZLN3D
PZLN3D
:
:
Quick Setup Guide
Batteries: AAA × 2 3D Glasses × 1
Screw (M4×L12) × 6
Screw (M5×L12) × 10• Screw (ST4×L14) × 2
Screw (ST4×L14) × 2
glasses may not be supported.
Warranty Card
Screw (M5×L12) × 4
INSTALLING THE STAND2
CAUTION
Carefully place your TV facedown on a soft, cushioned surface to prevent damage to the TV or scratching to the screen.
1 2
Stand Column
Base
Screws: M4×L12 (50K610)
M5×L12 (55K610)
Secure the stand column to the base plate with the 4 screws.
Secure the stand cover to the stand column vertically with the 2 screws.
43
Stand Cover
Screws:
ST4
×L14
Stand Column
Secure the stand cover to the stand column horizontally with the 2 screws.
Secure the stand to the TV with the 4 screws.
NOTE
Product image is only for reference, actual product may vary in appearance.
SECURING THE INSTALLATION SPACE
Make sure that your TV has adequate air circulation. Allow enough space around the TV as shown below. Avoid operating the TV at temperatures below Inadequate air 41°F (5°C).
Install with stand
12 inches
(30cm)
4 inches
(10cm)
Never install the TV set as follows:
Air circulation is blocked.
CAUTION
Inadequate air circulation can lead to overheating of the TV and may cause damage to your TV or cause a fire.
4 inches
(10cm)
Screws: M4×L12 (50K610)
Leave at least this much space around the set.
M5×L12 (55K610)
Screws:
4 inches
(10cm)
Stand Cover
Stand Column
×L12
M5
Wall
3
Time shift of images on USB devices
only applicable when the TV program
VIEWING THE REMOTE CONTROL
Power Standby button: Power on
Select sound mode
Select picture mode
Select a channel or input numbers
Return to the previous channel
Display the main menu
/ Back menu display
▲/▼/◄/►: Up/Down/Left/Right
Return the previous menu
Fast access to your saved favorite
Open the HiSmart Hub
Enter the Opera browser
Start video recorder in DTV mode
Turn Subtitles on or off
Switch between different audio
/ Standby
channels
Adjust the volume
has the feature
VOL
Picture
Last
Menu
Return
PVR
Subtitle
Sound
T.shift
AudioI/I I
Sleep
OK
Mute
HiSmart
Text
Size
Zoom
Source
3D
PG
E
Info
Exit
HiMedia
Mix
Still
Remote sensing window
Select input sources
Set the TV sleep timer
3D button
Display the Electronic Programming Guide in DTV mode
Special function buttons
Display TV program and input source information
Confirm the selection / Display a list of channels saved in TV tuner memory
Exit the menu
Select a channel
CH
Mute and restore sound
HiMedia (digital multimedia player) button
Media player controls: Rewind, Play / Pause, Fast Forward, Previous, Stop and Next
Enter the Teletext mode Mix Teletext with TV pictures
Freeze a picture on screen
Adjust aspect ratio / Adjust Teletext size
CHANGE THE BATTERIES
1. Slide open the battery cover on the back of the remote control.
2. Install two AAA size (1.5V) batteries. Match the “+” and “-” signs on the batteries to the signs on the battery compartment.
3. Close the battery cover.
1 2 3
Gently Push
NOTES
Dispose of your batteries in a designated disposal area. Do not throw the batteries into fire.
Do not mix battery types or combine used batteries with new ones. Remove depleted batteries immediately to prevent battery acid from leaking into the
battery compartment. If you do not intend to use the remote control for a long time, remove the batteries. The effective range of remote control is suggested in the figure below.
REMOTE CONTROL RANGE
1. The maximum distance is 8 meters in front of the TV set.
2. The remote control is effective within 30 Degrees of horizontal angle, or 15 Degrees of vertical angle at maximum distances of 6 meters.
6m
8m
6m
15°
15°
30° 30°
8m
6m6m
TV Back View
DIGITAL AUDIO OUT
AC Power Cord
HDMI 4/ARC HDMI 3LAN
Power Switch
VIDEO
PBP
Y
COMPONENT IN
TV Bottom Panel
AV IN
L AUDIO
R
R
Check the jacks' for position and type before making any connections. Loose connections can result in image or color problems. Make sure that all connections are tight and secure.
Connect an outdoor VHF/UHF antenna.
ANT
Outdoor Antenna
OR
Antenna Cable (75)
LAN
Connect an ethernet cable to access a network or the Internet.
LAN
Turning the TV On for the First Time
The Installation Guide Menu appears the first time you turn on the TV. It will assist you to specify the Language Setting, Country Setting, Time Zone Setting (just for Australia area), Use Mode, Network Setting and Channel Search
Press [POWER] to turn on your TV, it will go straight into Setup Wizard menu
Press [///] buttons to navigate the menu and change the settings. Press [OK]
button to confirm.
Language Setting - Select your desired language to be displayed on the menu.
Country Setting - Select the country where you will operate the TV.
Time Zone Setting - Select the local time zone according to your region.
Use Mode - Select your Mode Setting: Home Mode or Shop Mode.
Home Mode is the recommended setting which offers full functionality of the television.
Network Setting - Connect an Ethernet cable to access a network or the Internet. TV also
features wireless connectivity. For more information, see “Using the Network Menu”.
Channel Search - Search and store all available TV channels automatically.
HDMI / COMP / AV
Connect an HDMI cable or Comp/AV Adapter from an external A/V equipment. No sound connection is needed for HDMI to HDMI connection. If the device signal resolution does not match the specification table you need to change the setting of device according to the table. Please consult your device user manual for instruction.
To select the HDMI / Component / AV
Press [Source] button, when the list of Input Source appears, press [▲/▼] to select the
source [HDMI] / [Component] / [AV], then press [OK] to connect.
Video Eect:
BEST (HDMI)
R
L AUDIO
AV IN
VIDEO
R
P
B
P
Y
COMPONENT IN
BETTER (COMP)
GOOD (AV)
Component
AV
Y
P
Pr
L
R
Video
L
R
b
VHF/UHF Antenna
ANT OUT
LAN
Video Camera/
Set-top Box/
Satellite Receiver
HDMI 2 HDMI 1 USB 3 USB 2 USB 1
ANT
AUDIO
PC IN
VGA
DC 5V 0.5A(MAX)
5
Model HL50K610PZLN3D HL55K610PZLN3D
Size with base (mm)
Size without base (mm)
Weight with base (kg)
Weight without base (kg)
Screen Diagonal Size
Screen Resolution
Sound Output (RMS)
Power Consumption
Power Supply
Colour System
Television System
Environmental Conditions
Component mode
VGA mode
HDMI mode
Features, appearance and specifications are subject to change without notice.
PC
USB
Connect a USB 2.0 device port for browsing photos, listening music and watching recorded movies.
• To select the USB device: Press [Source] button, when the list of Input Source appears, press [▲/▼] to select the source [HiMedia], then press [OK] to connect.
Or press [HiMedia] to directly enter the HiMedia menu
Portable Storage
Device
DIGITAL AUDIO OUT
Connect an optical cable from an external digital audio system (Toslink optical cable is needed).
Speaker
HEADPHONE
Connect Headphone for audio out of the TV.
Headphone
SPECIFICATIONS
1126×730×285
1126×658×59
20.6
17.6
50 inches
1920 × 1080
10 W + 10 W
125 W 115 W
100V - 240V 50Hz/60Hz
PAL NTSC
PAL B DVB-T
Temperature: 5°C - 45°C Humidity: 20% - 80% RH Atmospheric pressure: 86 kPa - 106 kPa
480I/60Hz, 480P/60Hz, 576I/50Hz, 576P/50Hz, 720P/50Hz, 720P/60Hz, 1080I/50Hz, 1080I/60Hz, 1080P/50Hz, 1080P/60Hz
640×480, 800×600, 1024×768, 1280×1024 60Hz
480I/60Hz, 480P/60Hz, 576I/50Hz, 576P/50Hz, 720P/50Hz, 720P/60Hz, 1080I/50Hz, 1080I/60Hz, 1080P/50Hz, 1080P/60Hz 640×480, 800×600, 1024×768
NOTE
you refer to the Trouble Shooting tips in the User Manual.
1248×803×330
1248×743×59
26.6
22.6
55 inches
1920 × 1080
10 W + 10 W
Loading...
+ 1 hidden pages