FingerTec TA200 Installation Guide
Installation Guide
Step 1
Determine the Location and Positioning
of the Installation
Avoid installing the terminals in locations that has contact with
•
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
• Avoid installing the terminals in locations with high moisture or
condensation levels in the air
• The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting of Terminals
A. MOUNT ON WALL
B. FLEXI KIT
FingerTec offers flexi-kit for all its time attendance models. Attach
the terminal on the flexi-kit for convenience.
Step 3
Wiring for Power Supply
The power jack is positioned at the rear of the terminal, labeled
Power Adapter Port in the below diagram.
TA200 Plus
TA200 Plus
Fingerprint Color Multimedia for
Time Attendance System
© 2014 Timetec Computing Sdn Bhd. A ll rights reserved.• 092014
Back Plate
4 feet / 1.2 meter
(recommended)
• After determining the height of the terminal from the ground
level and have made the relevant marks on the wall, drill the
screws into the wall to hang the back plate.
Refer to Appendix II for dimensions and measurements of instal
lation.
USB PORT
TCP/IP PORT (LAN)
POWER
ADAPTER PORT
Step 4
Setting Up Data Communications
(Skip this step if you are using USB ash disk to transfer data)
TCP/IP – LAN Connection
For TCP/IP connection, plug the special RJ45 jack into the TCP/IP
(LAN) Port of the terminal. Connect the other end (normal RJ45
jack) to the local area network hub or a PC. Configure the device ID,
-
IP address, subnet mask and Gateway in the terminal (refer to the
hardware user manual for details).
Step 5
Finalizing the installation
1. Check that all cable connections are done correctly.
2. Attach the terminal to the corresponding back plates, tighten
the screws to secure the terminal on the wall
3. Switch on the power to the terminal.
4. Start using the terminal.
Other Accessories
AdapTec AC
R
O
L
O
O
C
K
D
T
I
M
E
R
Note:
All Accessories are offered at
http://accessory.fingertec.com
The AdapTec AC is a 12VDC power supply inclusive of a 110~240VAC
switching linear power. The AdapTec supplies 12VDC power to the
FingerTec terminal and door lock system as well as charges a 12VDC
7.0Ah backup battery simultaneously. During an event of a power
failure, the back up battery automatically provides power to the
terminal and maintains the door lock system. The AdapTec AC also
prevents a secured door from being opened if it has been tampered
with.
Appendix I
Terminal Dimensions and Measurements
Mini UPS
Mini UPS 12VDC is a mini portable backup power
supply with 12VDC output, supplying 12VDC
power for FingerTec Door Access & Time Attendance terminals.
Enclosures
FingerTec offers enclosures to protect the terminals from being meddled with by unauthorized persons.
Flexi Kit
A foldable stand for FingerTec products, simplifies installation and
presentable. (Example on Step 2, B.)
Front View of TA200 Plus
Loading...