Black180 nozzles
Color900 nozzles (180 nozzles per color × 5)
Print directionBidirectional with logic seeking
Input Buffer256KB
Ink Cartridges
SpecificationBlack ink cartridge Color ink cartridges
Color(s)BlackCyan, Magenta, Yellow,
Storage
temperature
Transit
temperature
Freezing
temperature*
Dimensions1.7 × 3.3 × 0.5 inches (W × D × H)
* Ink thaws and is usable after approximately 3 hours at 77 °F (25 °C).
– 4 to 104 °F (– 20 to 40 °C)
1 month at 104 °F (40 °C)
– 22 to 122 °F (– 30 to 50 °C)
10 days at 122 °F (50 °C)
3.2 °F (– 16 °C)
42 mm × 83 mm × 13 mm (W × D × H)
Light Cyan, Light
Magenta
Paper
Since the quality of any particular brand or type of paper may
be changed by the manufacturer at any time, Epson cannot
attest to the quality of any non-Epson brand of paper. Always
test samples of paper stock before purchasing large quantities
or printing large jobs.
Poor quality paper may reduce print quality and cause paper
jams and other problems. If you encounter problems, switch
to a higher grade of paper. Do not load curled, folded, or
wrinkled paper.
Use paper under normal environmental conditions: 59 to
77 °F (15 to 25 °C) and 40 to 60% RH (relative humidity).
To ensure good results, use genuine Epson cartridges. Other
products may cause damage to your printer not covered by Epson’s
warranty.
Don’t use an ink cartridge if the date on the package has expired.
Do not refill the ink cartridge. An IC chip on the cartridge calculates
the amount of remaining ink based on the initial supply. Adding ink
does not increase the amount available for use.
2 - Epson Stylus Photo RX7005/05
B-LB-R
C
Single sheets or cards
Envelopes
Epson Stylus Photo RX700
Margins
Standard sheetsTop (A): 0.12 inch (3.0 mm)
Left (B-L): 0.12 inch (3.0 mm)
Right (B-R): 0.12 inch (3.0 mm)
Bottom (C): 0.12 inch (3.0 mm)
With minimum
margin settingTop (A): 0.10 inch (2.5 mm)
Left (B-L): 0.10 inch (2.5 mm)
Right (B-R): 0.10 inch (2.5 mm)
Bottom (C): 0.10 inch (2.5 mm)
EnvelopesTop (A): 0.12 inch (3.0 mm)
Left (B-L): 0.2 inch (5.0 mm)
Right (B-R): 0.2 inch (5.0 mm)
Bottom (C): 0.79 inch (20 mm) for
Windows and 0.12 inch (3.0 mm) for
Mac OS X
Note:
Depending on the type of paper, the print quality may deteriorate in
the top and bottom areas of the print, or these areas may be
smeared. Before printing large jobs using an extended margin setting,
print a single sheet to confirm print quality.
You can create borderless prints using certain special Epson papers.
®
®
Scanning
Scanner typeFlatbed color image scanner
Photoelectric deviceColor CCD line sensor
Effective pixels27,200 × 37,440 pixels at 3200 dpi,
100%
Document sizeLetter (8.5 × 11.0 inches) or A4
(8.5 × 11.7 inches); reading area is
selectable with software
Power consumptionApprox. 25 W (ISO 10561 Letter
(stand-alone copying) Pattern)
Approx. 2.5 W in sleep mode
Approx. 0.2 W in power-off mode
Environmental
Temperature
Operation50 to 95 °F (10 to 35 °C)
Storage*– 4 to 140 °F (– 20 to 60 °C)
1 month at 104 °F (40 °C)
Transit*– 4 to 140 °F (– 20 to 60 °C)
120 hours at 140 °F (60 °C)
Humidity (without condensation)
Operation20 to 80% RH
Storage*5 to 85% RH
* Stored in shipping container.
Interface
StandardBased on Universal Serial Bus
Specifications Revision 2.0, Universal
Serial Bus Device Class Definition for
Printing Devices version 1.1; Universal
Serial Bus Mass Storage class Bulk-only
Transport Revision 1.0
Bit rate480 Mbps (high speed device)
Data encodingNRZI
ConnectorUSB Series B
Recommended
cable length6.6 feet (2 meters) or less
5/05Epson Stylus Photo RX700 - 3
Epson Stylus Photo RX700
T
ddl
Safety Approvals
Safety standardsUL 60950, CSA C22.2 No. 60950
EMCFCC part 15 subpart B class B
CSA C108.8 class B
Supported Memory Cards
op slot
Mi
e slot
Bottom slot
SmartMedia (maximum 128MB;
standard 2000 compliant)
xD-Picture Card
Memory Stick (max. 128MB)
Memory Stick Duo *
Memory Stick PRO
Memory Stick PRO Duo
MagicGate Memory Stick
MagicGate Memory Stick Duo*
SD (Secure Digital) Card
MMC (MultiMediaCard)
miniSD Card*
* Adapter required
CompactFlash Type I and Type II
IBM Microdrive
TM
TM
®
®
TM
TM
TM
Loading Paper
Loading Plain Paper
The front tray is for loading letter-size plain paper only
(8.5
× 11-inch photocopier paper). You can load up to
150 sheets of 17-pound plain bond paper in the front tray.
Caution:
All other types of paper must be loaded in the rear sheet feeder
(see page 5).
1. Open the front cover.
Press
2. Fan a stack of paper (up to 150 sheets), then tap it on a flat
surface to even the edges.
3. Load the paper. Align it with the line on the yellow sticker,
being careful not to push it in too far.
Memory Card Image File Requirements
File formatJPEG or TIF format image files,
DOS FAT taken with a DCF
version 1.0 compliant digital camera
(supports Exif Print v. 2.1 and 2.2)
Media formatDCF (Design rule for Camera File
system) version 1.0 compliant*
Image size80 × 80 to 4600 × 4600 pixels
Number of filesUp to 999
* The DCF standard is set by the Japan Electronics and Information Technology
Industries Association (JEITA).
Note:
You can’t print images whose file names contain double-byte
characters, as is the case with some Asian language fonts. Do not
use Asian language fonts to name your files if you will be printing
from the memory card.
4 - Epson Stylus Photo RX7005/05
Caution:
Do not push the paper in too far. Make sure the paper is stacked
evenly.
Too far inEdges not even
Epson Stylus Photo RX700
4. Slide the edge guide against the left side of the paper.
5. Extend the output tray.
Loading Epson Paper
Load specialty Epson papers in the rear sheet feeder only.
Plain paper may also be loaded in the rear sheet feeder, but
you have to specify
printing (see page 6).
Note:
Epson paper is designed to work with Epson printers and ink. If you
use different brands, you may not get the results you expect.
Plain(Back) as the Paper Type when
2. Open the front cover.
Press
3. Extend the output tray.
4. Load your paper and slide the edge guide lightly against it.
Never load more sheets than can fit under the arrow mark
on the edge guide.
1. Extend the paper support.
Note:
If you’re using Epson paper, follow any instructions that came with it.
For example, some types of paper should be loaded only one sheet at
a time. See the electronic Reference Guide for details.
To ensure good results, always:
■Load paper short edge first.
■Load paper with the printable side up (it’s usually whiter or
brighter).
■Check the RX700’s Paper Type setting before printing to make
sure it matches the type of paper you’ve loaded (see page 7).
5/05Epson Stylus Photo RX700 - 5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.