Datalogic ADC, Inc.
959 Terry Street
Eugene, OR 97402
USA
Telephone: (541) 683-5700
Fax: (541) 345-7140
©2013-2015 Datalogic, Inc.
An Unpublished Work - All rights reserved. No part of the contents of this documentation or the procedures described therein may be reproduced or transmitted in any form or by any means without prior written permission of Datalogic ADC, Inc. or its subsidiaries or affiliates ("Datalogic" or “Datalogic ADC”). Owners of Datalogic products are hereby granted a non-exclusive, revocable license to reproduce and transmit this documentation for the purchaser's own internal business purposes. Purchaser shall not remove or alter any proprietary notices, including copyright notices, contained in this documentation and shall ensure that all notices appear on any reproductions of the documentation.
Should future revisions of this manual be published, you can acquire printed versions by contacting your Datalogic representative. Electronic versions may either be downloadable from the Datalogic website (www.datalogic.com) or provided on appropriate media. If you visit our website and would like to make comments or suggestions about this or other Datalogic publications, please let us know via the "Contact Datalogic" page.
Disclaimer
Datalogic has taken reasonable measures to provide information in this manual that is complete and accurate, however, Datalogic reserves the right to change any specification at any time without prior notice.
Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in many countries, including the U.S.A. and the E.U. All other brand and product names may be trademarks of their respective owners.
Patents
See www.patents.datalogic.com for patent list.
This product is covered by one or more of the following patents:
Design patents: EP002158717, USD723563, ZL201330271434.1
Utility patents: EP0996284B1, EP0997760B1, EP0999514B1, EP1128315B1, EP1396811B1, EP1413971B1, EP1828957B1, JP4435343B2, US6478224, US6512218, US6513714, US6561427, US6808114, US6997385, US7053954, US7075663, US7234641, US7387246, US7721966, US8245926, US8561906
QuickScan™ I QD2430
General Purpose Corded
Handheld Area Imager
Bar Code Reader
Regulatory Addendum
850020014 |
(Rev. A) |
April 2016 |
|
|
|
|
|
|
|
|
|
This document is an addendum to the Quick Reference Guide (QRG) for this product. See the QRG for additional product information.
©2013-2015 Datalogic, Inc.• All rights reserved. Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in many countries, including the U.S.A. and the E.U.
www.datalogic.com
Regulatory Information
All models are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required.
Any changes or modifications to equipment, not expressly approved by Datalogic could void the user's authority to operate the equipment.
Statement of Agency Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Class B Compliance Statement
The user is cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio or television technician for help.
Canadian Notice
This equipment does not exceed the Class B limits for radio noise emissions as described in the Radio Interference Regulations of the Canadian Department of Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de la classe B prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada.
Do not attempt to open or otherwise service any compo-
nents in the optics cavity. Opening or servicing any part of the optics cavity by unauthorized personnel may vio-
CAUTION late safety regulations.
Customs Union
The CU conformity certification has been achieved; this allows the Product to bear the Eurasian mark of conformity.
Power Supply
This device is intended to be connected to a UL Listed/CSA Certified computer which supplies power directly to the reader or else be supplied by UL Listed/CSA Certified Power Unit marked “Class 2” or LPS power source rated 5-14V minimum 900mA.
QD2430 can be powered by either a 5V or 12V power supply.
Argentina Power Supply Statement
|
Características de la fuente |
||
|
|||
|
de alimentación eléctrica. |
||
|
|
5 V |
|
|
Entrada: |
100 - 240 Vca |
|
Atencíon |
|||
350 mA, 50-60 HZ |
|||
Salida: |
5VDC, 2.5A |
||||
(-)Negativo al centro |
|||||
|
|
|
|
||
|
|
|
|
12 V |
|
|
|
|
|
||
Entrada: |
100 - 240 Vca |
||||
600 mA, 50-60 HZ |
|||||
|
|
|
|
||
Salida: |
12VDC, 1500mA |
||||
(-)Negativo al centro |
|||||
|
|
|
|
||
|
|
|
|
|
|
Utilice en su red solo fuentes certificadas en Argentina.
El uso de fuentes de alimentación no compatibles puede resultar en riesgo de incendio o de choque eléctrico para el usuario.
Imager Labeling
Sample labels are shown here to illustrate their location only. Please view the labels on your product for actual details, as they may vary from those depicted.
Scanner Regulatory Label
The QuickScan™ Handheld Reader is not user-service- able. Opening the case of the unit can cause internal
damage and will void the warranty.
CAUTION
Loading...