Canon D860 SERVICE MANUAL
Set-Up Instructions
Series
1
Set-Up Instructions
Thank you for purchasing Canon imageCLASS D800 Series.
To get your machine ready for use, please follow the instructions in this document before referring to any other documentation.
Unpack the machine and its components.
Check that you have the following:
• Power cord
• Telephone cable*
• Documentation
Set-Up Instructions
Machine
L50 S-Cartridge
Basic Guide
Fax Guide*
Registration Card**
Limited Warranty Notice
• CD-ROM
Output tray
Destination labels*
Remove the shipping materials.
Place the machine on a flat surface.
1
Remove
2
3 4
2
all shipping tapes from the exterior of the machine.
Lift the platen unit
1 and slide the
lever
platen unit to the left
2.
Open the cartridge
cover.
65
* imageCLASS D880 Model
** U.S.A. only
Slide the platen unit
to the left until the
I4 mark appears.
Remove the shipping
material.
Install the cartridge.
1
3
5
Remove the cartridge
from its bag.
Place the cartridge on
a flat and stable
surface, grip the
sealing tape tab,
and snap in the
direction shown. Make
sure that the tab is
detached from the
cartridge.
Remove the sealing
tape completely.
2
4
6
Rock the cartridge
several times to
distribute the toner
evenly.
Grasp the cartridge
with one hand, firmly
and slowly pull out
the sealing tape tab
with the other hand.
Slide the cartridge
into the machine with
the arrow mark up as
far as it will go.
1
Load paper.
Pull out the
cassette until it
stops.
2
Arrow Mark
Close the cartridge
cover and slide the
platen unit back to the
original position.
Load the paper stack beneath
the cassette’s length guide
and width guides 2.
Make sure that the paper stack does not
exceed the length and width guides in
the cassette. Failure to do so will cause a
paper jam.
Gently insert the cassette as
far as it will go.
1
PARALLEL
PAR
USB interface connection
Connect to your computer using USB cable.
Attach the output tray.
L
1
Hook the tab on
the output tray
onto the opening
on the left side of
the machine.
Connect the telephone cable and any necessary external device.
(Only for the imageCLASS D880 model)
Connect external devices as follows:
LL
:Telephone line jack
:External device jack
•Telephone or answering machine
Telephone or answering
machine
TEL.
LINE
Answering
machine
LINE
Modem
Serial
Connector
Computer
LINE
Computer
TEL.
TEL.
Telephone
Telephone
Telephone
Telephone line cord
Connect the supplied
telephone line to the
L
jack.
Then connect the other end to the
telephone line jack on your wall.
External device (optional)
Connect the cord of an
extension telephone,
answering machine or
data modem to the jack.
Telephone
line
•Telephone and answering machine
Telephone
line
•Telephone and modem (external modem)
Telephone
line
•Built-in computer modem and telephone
LL
Machine
LL
Machine
LL
Machine
LL
Machine
Connect the machine to your computer.
NOTE
●
Printer cables are not included.
Using a parallel cable
Make sure that the computer is turned off before connecting the cable.
Parallel interface connection
Make sure that the other end is securely connected
to your computer.
Using a USB cable
USB interface connection
Make sure that the other end is securely connected
to your computer.
Loading...