Copyright
Copyright © 2001 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company.
Disclaimer
This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Further, this company reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation of this company to notify any person of such revision or changes.
Canadian Department of Communications
Regulatory Statement
This digital apparatus does not exceed Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radio-électriques dépassant les limites applicables aux appareils numériques de la classe B prescrites dans le Réglement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.
FCC Class B Radio Frequency
Interference Statement
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
User’s Guide
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4.Consult the dealer or an experienced radio/television technician for help.
Notice 1:
The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Notice 2:
Shielded interface cables must be used in order to comply with the emission limits.
Notice 3:
This product complies with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating Electromagnetic Compatibility (89/336/EEC). For the evaluation regarding the electromagnetic compatibility, the following standards were applied:
EN50082-1, IEC 801-2, IEC 801-3, IEC 801-4 EN50081-1, EN55022
D.N.S.FI. Regulatory Statement
Class 1 laser product (EN 60825: 1991)
or
Luokan 1 laserlaite Klass 1 laser apparat (EN 60825: 1991)
Additional remarks:
VAROITUS - Laitteen käyttäminen muulla kuin tässä käyttöohjeessa mainitulla tavalla saattaa altistaa käyttäjän turyallisuusluokan 1 ylittävälle näkymättömälle lasersäteilylle.
Varning - Om apparaten används pä annat sätt än i denna bruksanvisning specificerats, kan användaren utsättas för osynlig lasersträlning, som överskrider gränsen för laserkläss 1.
According to EN 60825 sub-clause 6, regarding actions to be taken against dangerous radiation including copies of all warning labels and information about the laser components and radiation data such as wavelength, output power and pulse times.
User’s Guide
Safety instructions
1.Follow all warnings and instructions marked on the product.
2.DANGER: Invisible laser radiation when open. Avoid direct exposure to beam.
3.Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4.Openings in the front panel and the back or bottom are provided for ventilation. To protect it from overheating, these openings must not be blocked or covered. This product should never be placed near or over a radiator or heat register, or in a built-in installation unless proper ventilation is provided.
5.A suitable power adapter must be obtained through the authorized dealer or franchisee.
6.Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short cut parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.
User’s Guide
Table of Contents |
|
NOTICE ABOUT USING AN EXTERNAL USB CD-REWRITER ......................................... |
2 |
MATAIN THE DEVICE PERFORMANCE ........................................................................ |
2 |
PREVENT FROM THE “BUFFER UNDERRUN” ERROR .................................................... |
2 |
RECOMMENDED SYSTEM CONFIGURATIONS............................................................... |
3 |
PRODUCT DESCRIPTION........................................................................................... |
4 |
FRONT VIEW ........................................................................................................... |
4 |
REAR VIEW............................................................................................................. |
5 |
LEFT VIEW .............................................................................................................. |
5 |
INSTALLATION ......................................................................................................... |
6 |
HARDWARE INSTALLATION ....................................................................................... |
6 |
CD WRITING SOFTWARE INSTALLATION ..................................................................... |
8 |
OPERATION INSTRUCTIONS ...................................................................................... |
9 |
LOAD A CD DISC ..................................................................................................... |
9 |
REMOVING A CD DISC ............................................................................................. |
9 |
MAINTENANCE......................................................................................................... |
9 |
EMERGENCY EJECT................................................................................................. |
9 |
FREQUENTLY ASKED QUESTION (FAQ)..................................................................... |
10 |
TECHNICAL SUPPORTS ............................................................................................ |
14 |
HOW TO FIND THIS INFORMATION .............................................................................. |
14 |
MS-DOS, Windows 95, Windows 98, and Windows NT are registered trademarks of Microsoft Corporation. Pentium is a registered trademark of Intel Corporation. Names of products mentioned herein are used for identification purposes only and may be trademarks and/or registered trademarks of their respective company.
All specifications subject to change without notice.
User’s Manual |
E-1 |
|
Notice About Using An External USB
CD-Rewriter
Maintain The Device Performance
If you want to maintain the CD-Rewriter’s better performance, we recommend you connecting only one of the CD-Rewriter to your computer at a time. However, there is an extreme reduction in performance when two or more of fast USB devices (such as CD-ROM, CD-Writer, scanners, printers and hard drive) are used simultaneously.
NOTE: Please make sure your computer meets the system requirements (or system configurations) shown on the box or on the next page of this manual.
Prevent From the “Buffer Underrun” error
What is a buffer underrun? An uninterrupted data flow to the CD-Recorder drive is needed when using mastering software like Easy CD Creator. A buffer underrun occurs when the PC cannot consistently send the required data flow writing to the CD-Recorder. If a buffer underrun occurs during writing, your CD-R disc is unusable anymore. To understand how to prevent from the buffer underrun error, please refer to “What can I do to prevent Buffer underrun?” on page E-11.
User’s Manual |
E-2 |
|
Recommended System Configurations
The system requirements listed below are recommended for ensuring consistent writing performance.
ŠOperating system: Windows 98 or higher
ŠRAM: 32 MB or larger.
ŠCPU: Pentium 166 MHz or above
ŠHard disc drive: Minimum 50 MB of free space for installing software. 750 MB free HD is needed when duplicating a CD through HD (10 MB free space for each minute of recorded music).
ŠAn available USB (Universal Serial Bus) port.
User’s Manual |
E-3 |
|
Loading...