GNE114610APX
Please read this manual first!
Dear Customer,
We hope that your product, which has been produced in modern plants and checked under the most meticulous quality control procedures, will provide you with years of good service.
For this, we recommend you to carefully read the entire manual of your product before using it and keep it at hand for future reference.
This manual
•Will help you use your appliance quickly and safely.
•Read the manual before installing and operating your product.
•Follow the instructions, especially those for safety.
•Keep the manual in an easily accessible place as you may need it later.
•Besides, read also the other documents provided with your product.
Please note that this manual may be valid for other models as well.
Symbols and their descriptions
This instruction manual contains the following symbols:
C Important information or useful usage tips.
AWarning against dangerous conditions for life and property.
BWarning against electric voltage.
This product is supplied with the selective sorting symbol for waste electrical Recycling and electronic equipment (WEEE).
This means that this product must be handled pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimise its impact on the environment. For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of hazardous substances.
CONTENTS
1 Your refrigerator |
3 |
2 Warnings |
4 |
ELECTRICAL REQUIREMENTS.......... |
5 |
WARNING! THIS APPLIANCE MUST BE |
|
EARTHED.......................................... |
5 |
ENERGY SAVING TIPS...................... |
6 |
3 Installation |
7 |
Points to be considered when re- |
|
transporting your refrigerator.............. |
7 |
Before operating your refrigerator....... |
7 |
Electric connection............................. |
8 |
Disposing of the packaging................ |
8 |
Disposing of your old refrigerator........ |
8 |
Placing and Installation....................... |
9 |
Floor balance adjustment................... |
9 |
Adjusting the gap between the upper |
|
door................................................. |
10 |
5 Using your refrigerator 12 |
|
Indicator Panel................................. |
12 |
Door Open Alarm: ........................... |
14 |
Egg tray........................................... |
15 |
Sliding Body Shelves........................ |
15 |
Crisper ............................................ |
15 |
Chiller compartment......................... |
15 |
Rotating Middle Section .................. |
16 |
Multi Zone Storage Compartment |
.. 16 |
Blue light.......................................... |
16 |
6 Maintenance and |
|
cleaning |
17 |
Protection of plastic surfaces .......... |
17 |
7 Recommended solutions |
|
for the problems |
18 |
8 Guarantee Details |
21 |
4 Preparation |
11 9 How To Obtain Service 22 |
|
|
|
|
2EN
1 Your refrigerator
Congratulations on your choice of a BEKO quality Appliance which has been designed to give you service for many years.
A
|
12 |
3 |
13 |
2 |
|
1 |
|
4 |
|
5 |
|
6 |
|
7 |
14 |
8 |
|
9 |
15 |
10 |
|
11 |
|
|
16 |
|
B |
|
C |
A- |
Fridge compartment |
|
|
B- |
Freezer compartment |
|
|
C- |
Multi Zone |
|
|
1- |
Fridge compartment door shelves |
8- |
Bottle shelf |
2- |
Fridge compartment adjustable |
9- |
Icematic |
cabinet shelves |
10- |
Icebox |
|
3- |
Diffuser cover |
11Frozen food storage compartments |
|
4- |
Illumination lens |
12Butter & Cheese shelf cover |
|
5- |
Rotating middle section |
13Butter & Cheese shelf |
|
6- |
Chiller compartment |
14- |
Bottle holder |
7- |
Crisper |
15Multi Zone compartment shelves |
|
|
|
16Multi Zone compartment |
|
CFigures that take place in this instruction manual are schematic and may not correspond exactly with your product. If the subject parts are not included in the product you have purchased, then it is valid for other models.
3EN
|
Warnings |
|
|
|
2 |
|
|
||
•DO |
NOT connect your appliance to |
• To obtain the best possible performance |
||
the electricity supply until all packing |
||||
and trouble free operation from your |
||||
and transit protectors have been |
||||
appliance it is very important to carefully |
||||
removed. |
||||
read these instructions. |
||||
• Leave to stand for at least 4 |
||||
• On delivery, check to make sure that |
||||
hours before switching on to allow |
||||
the product is not damaged and that all |
||||
compressor oil to settle if transported |
||||
the parts and accessories are in perfect |
||||
horizontally. |
||||
condition. |
||||
• If you are discarding an old |
||||
• Ensure that the plug remains readily |
||||
refrigerator with a lock or latch fitted |
||||
accessible. Do not use multiple adapter bar |
||||
to the door, disable the lock/latch, |
||||
or extension cable. |
||||
ensure that it is left in a safe condition |
||||
• Failure to observe these instructions may |
||||
to prevent the entrapment of young |
||||
invalidate your right to free service during |
||||
children. |
||||
the guarantee period. |
||||
• This fridge/freezer must only be used |
||||
• Keep ventilation openings, in the |
||||
for its intended purpose i.e the storing |
appliance enclosure or in the built-in |
|||
and freezing of edible foodstuff. |
||||
structure, clear of obstruction. |
||||
• Do not dispose of the appliance on |
||||
• Do not use mechanical devices or |
||||
a fire. At BLOMBERG, the care and |
||||
other means to accelerate the defrosting |
||||
protection of our environment is an |
||||
process, other than those recommended |
||||
ongoing commitment. This appliance |
||||
by the manufacturer. |
||||
which is among the latest range |
||||
• Do not damage the refrigerant circuit. |
||||
introduced is particularly environment |
||||
• Do not use electrical appliances inside |
||||
friendly. Your appliance contains non |
||||
the food storage compartments of the |
||||
CFC / HFC natural substances in the |
||||
appliance, unless they are of the type |
||||
cooling system (Called R600a) and in |
||||
recommended by the manufacturer. |
||||
the insulation (Called cyclopentane) |
||||
• We suggest you keep these instructions |
||||
which are potentially flammable |
||||
if exposed to fire. Therefore, take |
in a safe place for easy reference. |
|||
care not to damage, the cooling |
• This appliance is not intended for use by |
|||
circuit / pipes of the appliance in |
persons (including children) with reduced |
|||
transportation and in use. In case of |
physical, sensory or mental capabilities, |
|||
damage do not expose the appliance |
or lack of experience and knowledge, |
|||
to fire or potential ignition source and |
unless they have been given supervision or |
|||
immediately ventilate the room where |
instruction concerning use of the appliance |
|||
the appliance is situated. |
by a person responsible for their safety. |
|||
• We suggest you contact your local |
• Children should be supervised to ensure |
|||
authority for disposal information and |
that they do not play |
|||
facilities available. |
with the appliance. |
|||
• See Installation Instructions on on |
|
|
||
page 9 for information on suitable |
|
|
||
location. |
|
|
||
4EN
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the frequency shown on the rating plate inside the appliance corresponds to yourelectricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance be connected to the mains supply via a
suitable switched and fused socket. The appliance must be positioned so that the plug is accessible.
Should the mains lead of the appliance become damaged or should it need
replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a BLOMBERG Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted.
Destroy the old plug which is cut off as a plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: (See diagram).
1. Connect the green-yellow or green
(Earth) wire to the terminal in the plug marked ‘E’ or with the symbol 
or coloured green and yellow or green.
2.Connect the blue (Neutral) wire to the terminal in the plug marked ‘N’ or coloured black.
3.Connect the brown (Live) wire to the terminal in the plug marked ‘L’ or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.
GREEN & |
|
6mm. |
|
|
|
|
|
YELLOW |
|
|
|
OR |
|
L |
|
GREEN |
32mm. |
|
|
|
BROWN |
|
|
|
|
6mm. |
|
N |
|
OR |
|
|
RED |
|
|
BLUE |
|
22mm. |
|
6mm. |
|
12mm. |
|
BLACK |
|
||
OR |
|
|
|
CORD GRIP
FUSE |
FITTED WITH 1362 13A FUSE ALWAYS |
BS 1362 REPLACEMENT |
CARTRIDGE FUSE |
|
BS |
FIT |
|
5EN
ENERGY SAVING TIPS
1- Ensure your appliance is installed in a well ventilated area.
2- Ensure the time between buying chilled/frozen food and placing them in your appliance is kept at minimum, particularly in summer. We recommend you use a cool bag or a special carrier bag to carry frozen food.
3- Do not leave the door (s) of your appliance open longer than necessary and ensure they are closed properly after each opening.
4- Defrost frozen food in the fridge compartment, so that frozen food acts as an ice pack to assist cooling in the fridge.
6EN
3 Installation
B Please remember that the manufacturer shall not be held liable if the information given in the instruction manual is not observed.
•Original packaging and foam materials should be kept for future transportations or moving.
Points to be considered when re-transporting your refrigerator
1.Your refrigerator must be emptied and cleaned prior to any transportation.
2.Shelves, accessories, crisper and etc. in your refrigerator must be fastened securely by adhesive tape against any jolt before repackaging.
3.Packaging must be tied with thick tapes and strong ropes and the rules of transportation printed on the package must be followed.
Please do not forget…
Every recycled material is an indispensable source for the nature and for our national resources.
If you wish to contribute to recycling the packaging materials, you can get further information from the environmental bodies or local authorities.
Before operating your refrigerator
Before starting to use your refrigerator check the following:
1.Is the interior of the refrigerator dry and can the air circulate freely in the rear of it?
2.Insert the 2 plastic wedges onto the rear ventilation as illustrated in the following figure. Unscrew the existing ones and use the screws given in the same bag of wedges. Plastic wedges will provide the required distance between your refrigerator and the wall in order to allow the air circulation.
3.Clean the interior of the refrigerator as recommended in the “Maintenance and cleaning” section.
4.Plug the refrigerator into the wall outlet. When the door is open the respective interior light will come on.
5.You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, even if the compressor is not running and this is quite normal.
6.Front edges of the refrigerator may feel warm. This is normal. These areas are designed to be warm to avoid condensation.
7EN
Loading...