Whirlpool ADP 735 WH, ADG 734/2 AV, ADG 734/2 WH, ADP 734 WH, ADP 741/2 WH User Manual

GB			SUMMARY
BEFORE USING THE DISHWASHER				PAGE 11
PROTECTING THE ENVIRONMENT				PAGE 11
PRECAUTIONS AND GENERAL RECOMMENDATIONS				PAGE 11
ENERGY AND WATER SAVING TIPS				PAGE 11
HOW TO FILL THE SALT CONTAINER				PAGE 12
HOW TO FILL THE RINSE AID DISPENSER				PAGE 13
HOW TO FILL THE DETERGENT DISPENSER				PAGE 13
CONNECTIONS				PAGE 14
MAINTENANCE AND CLEANING				PAGE 16
TROUBLESHOOTING GUIDE				PAGE 17
AFTER-SALES SERVICE				PAGE 17

For maximum satisfaction from your dishwasher, carefully read these user instructions, consult the wash programme chart and the loading guide.

10

BEFORE USING THE DISHWASHER

•After unpacking, make sure the appliance is undamaged and that the door closes correctly. Do not use the appliance if it is damaged. If in doubt, consult your local retailer.

•Keep potentially hazardous packaging (plastic bags etc.) out of the reach of children.

•This appliance is designed for use in the home in compliance with its intended purpose.

•All water and electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions (refer to the enclosed installation booklet) and current local safety regulations.

PROTECTING THE ENVIRONMENT

1.Packing

The packing box may be fully recycled as confirmed by the recycling symbol .

2.Appliance

The appliance is built from reusable materials.

If you decide to scrap the dishwasher, it must be disposed of in compliance with local waste disposal laws. Before scrapping, cut off the power cable so that the appliance cannot be connected to the mains.

PRECAUTIONS AND GENERAL RECOMMENDATIONS

Child safety

•Do not allow children to play with the dishwasher.

•Store the detergent, rinse aid and salt in a dry place out of the reach of children.

General recommendations

•Only use detergents, rinse aids and regeneration salts (not applicable for Australia) specially recommended for use in domestic dishwashers.

•On completion of the wash programme switch off the dishwasher and turn off the water tap.

•Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap.

•If a fault occurs, switch off the appliance and turn off the water tap.

•The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it since the appliance may topple over.

•If necessary, the power cable may be replaced with one the same obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician.

•For appliances with water-stop system:

The water inlet hose and plastic casing contain electrical components. Do not therefore cut the hose or immerse the plastic casing in water. If the hose is damaged switch off the appliance immediately.

•Do not use solvents inside the dishwasher: risk of explosion!

•Load capacity: -12 place settings

EC Declaration of Conformity

This appliance has been designed, constructed and distributed in compliance with the safety requirements of

EC Directives:

•73/23/EC

•89/336/EC

•93/68/EC.

ENERGY AND WATER SAVING TIPS

• Do not rinse crockery under running water.	• If ecological energy sources are available
• Always fully load the dishwasher before	such as solar panel heating, heat pumps or
switching on.	centralised heating systems, the appliance
	may be connected to the hot water mains up
	to a maximum temperature of 60°C.
	Make sure the water inlet hose is of the
	correct type. Refer to the “Connections”
	chapter in these user instructions.

11

HOW TO FILL THE SALT CONTAINER

(Not applicable for Australia).

Check the water hardness level in your area. Consult your local Water Board or check your last water bill.

•If the water hardness level exceeds category 1, before using the dishwasher

for the first time, fill the salt container and run a wash cycle so that any excess saline solution discharged is immediately removed by the water to prevent corrosion. The pre-rinse cycle is not sufficient for this purpose.

• Check the salt level regularly.

• Important: Only use regeneration salts recommended for use in domestic dishwashers.

Do not fill the salt container with detergent as this will cause irreparable damage to the water softener system.

To fill the salt container:

1.Remove the lower rack.

2.Unscrew the cap by turning it counter-clockwise.

3.If the dishwasher is new, fill the salt container to the rim with water.

4.Fill the container to the rim with salt (max. 2 kg) and stir with a spoon handle.

5.Screw the cap back on by turning it clockwise.

Salt level indicator

The green float is clearly visible in the cap window when the salt container is full. The green float lowers and is no longer visible when the salt container is empty.

12