Whirlpool ADG 7966 Quick Reference Guide

Before using the dishwasher, read the user instructions!

ADG 7966	Quick Reference Guide			GB

Options

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

“Delayed start” button

The wash cycle can be programmed to start after 3-6-9 hours. Then press the Start button. The wash programme will

start at the set time.

“Half load” button

This function can be used with any programme. The indicator lamp switches on. The wash cycle is activated for the upper or lower rack only.

When washing without the top rack, press the “Half Load” button (LED alight).

Indicators

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately before starting a wash programme.

Programme chart			Detergent 2)		Consumption 3)
Programmes		Loading instructions	A	B	Litres	kWh	Minutes
Sensor max. 1)	40-70°C	Lightly, normally or heavily soiled, also	X	X	7.0-17.0	0.99-1.58	90-162
		suitable for pans and saucepans.
Pre-Rinse	cold	Crockery to be washed later.	-	-	4.0	0.03	14
Glass	40°C	Light soiling, for example glasses and	X	-	10.0	0.80	55
		cups.
Quickwash	40°C	Lightly soiled crockery with no dried-on	X	-	10.0	0.65	30
		food.
Hygiene + 4) 5)		Normally or heavily soiled crockery,	X	X	13.0	1.50	115
		with additional antibacterial action.

1)Reference programme for energy label EN 50242 (Liter = 13.0, kWh = 1.05, Min. = 145);

2)Refer to “User instructions”;

3)Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.

Important information for Test Laboratories:

4)The bacteria removal efficiency has been tested by the Institut Pasteur de Lille (France), based on the NF

EN 13697 standard of November 2001.

5)Programme interruption (e.g. the door being opened) may compromise the result of the antibacterial rinse.

For detailed information on the EN comparison test and other tests, contact the following address: “[e-mail]”.

Whirlpool is a registered trademark of Whirlpool USA

5019 396 91565

(We reserve the right to make technical modifications)

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Open the door, switch on the appliance

How to fill the detergent dispenser

Check the rinse aid level

Check the regeneration salt level

Load the racks

Select a programme

Select options

Press the Start button

Turn on the water tap close the dishwasher door

Press the ON button.

Large compartment A:
With each wash cycle.			A	B C
Small compartment B:
For programmes with pre-wash
only.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator D. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.

The last programme selected will light up.

Press the button until the desired programme lights up.

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is	“Change programme”
			Press the START button for 2 sec. until
then memorised (even in the			the Start indicator lamp switches off;
event of power failure).			Select another programme and press
			the START button again.

Wash cycle

Switch off the appliance

Turn off the water tap, unload the racks

-Only open the dishwasher if necessary (Warning: beware of hot steam).

-If the appliance is switched off during a

wash cycle, when switched on again it will resume the cycle from where it was interrupted.

At the end of the programme an acoustic signal will sound.

Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.