Whirlpool ADG 7560 User Manual

Before using the dishwasher, read the user instructions!

ADG 7560

Quick Reference Guide

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.

GB

Programme chart

Programmes Loading instructions A B

Pre-Rinse cold

Quickwash 40°C

1) 4)

Eco

Daily 60°C

Intensive 70°C

1) Reference programme for energy label in compliance with
EN 50242 regulations;

2) Refer to “User instructions“;

Important information for Test Laboratories:
For detailed information on the EN/Standard loading comparison test, contact the following address: “[e-mail]”.

Whirlpool is a registered trademark of Whirlpool USA

Crockery to be washed later. - - 5.0 0.02 10

Lightly soiled crockery, with no dried-on
food.

Normally soiled crockery. X X 16.0 1.05 195

50°C

Normally or heavily soiled crocke ry. X X 16.0 1.35 120

Recommended programme for heavily
soiled crockery , especially suitable f or pans
and saucepans.

3) Programme data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, options, water temperatures - above or
below 15°C - as well as water hardness and power supply
voltage, etc.

4) Energy saving programme with prolonged drying cycle.

Detergent

(We reserve the right to make technical modifications)

2)

Consumption

Litres kWh Minutes

X - 13.0 0.70 30

X X 17.0 1.65 145

5019 396 98139

3)

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Open the door,

switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Select options

Press the ON button.

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.
If using combined action dishwash er

tabs, follow the user instructions!

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener sy stem only .

Mechanical indicator D. Electric indicator
on control panel (if provi ded).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Press the button until the desired programme lights up.

If necessary (and if provided)
the corresponding indicator lamp lights up.

A:

B:

ABC

Press the Start button

Turn on the water tap

close the dishwasher door

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

The selected programme is th en
memorised (even in the event
of power failure) .

At the end of th e progr amm e an acoustic si gnal will soun d .
Only after the ST ART button has switched o ff: press th e
All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switch es o ff;

Select another programme and
press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switch ed of f d uring a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

OFF

button.