Whirlpool ADG 7340 Manual

Before using the dishwasher, read the installation and maintenance instructions carefully!

GB ADG 7340

1. OVERVIEW

ON button

OFF button

Programme selection button

Press the button repeatedly until the desired programme indicator lights up.

START button

The indicator lights up during operation, flashes when a fault occurs, and goes off at the end of the programme. START button RESET function:

Press this button for at least 2 seconds; the selected programme and options are cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. Detailed instructions are given in chapter 5 “What to do if...”.

Table 1.1.

	Programme chart			Detergent		Consumption 1)
				dispenser
P	Programmes		Loading instructions	large	small	Litres	kWh	Minutes
1	Quickwash	40°C	Lightly soiled crockery, with no dried-on	X	—	13.0	0.70	30 ± 1)
			food.
2	Eco 2)	50°C	Normally soiled crockery. Energy saving	X	X	15.0	1.05	165 ±	1)
			programme.
3	Intensive	70°C	Recommended programme for heavily					145 ± 1)
			soiled crockery, especially suitable for	X	X	17.0	1.65
			pans and saucepans.

1)Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.

2)Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison test and other tests, contact the following address: “[e-mail]”.

Whirlpool is a registered trademark of Whirlpool USA

5019 396 01152

1

2. QUICK REFERENCE GUIDE

Detailed instructions are given in the following pages, see also chapter “5. What to do if...”

1.Switch on the appliance

2.Select a programme

3.Select the type of detergent

4.Fill in the detergent

Open the dishwasher door.

Press the ON button.

Press the button

or to bring up the desired programme on the display.

Select options, if available.

The detergent selection procedure varies depending on the dishwasher model. Chapter “1. Overview” provides instructions for selecting detergent type.

4a. Powder/gel/tabs

Fill the detergent dispenser compartments in A B C accordance with the wash programme selected.

Large compartment A for every wash cycle, additional small compartment B for programmes with pre-wash

(see table 1.1.).

4b. Combined action detergents (2 in 1/3 in 1/... etc.) Place the detergent in compartment A, as per the manufacturer's recommendations.

5.Check the rinse aid level

6.Check the salt level

7. Load the racks

Visual indicator in dispenser C

dark		sufficient rinse aid present,
clear		add rinse aid (approx. 150 ml).

The indicator lamp on the control panel lights up when rinse aid needs to be added. Not all models are equipped with such an indicator.

Depending on the model:

window in salt reservoir cap on bottom of appliance inside

orange		when sufficient salt is present,
clear		when salt needs to be added.

The indicator lamp on the control panel lights up when salt needs to be added. Even once salt has been added, the indicator lamp only switches off after several wash cycles!

Make sure that the spray arms can turn freely and are not impeded by crockery or cutlery in the racks.

Detailed instructions on loading the racks are given in chapter “3. How to use the appliance”, under “How to load the racks”.

8.Start the appliance

9.Turn on the water tap and close the dishwasher door

Wash cycle

Press the START button.

When the door is closed the dishwasher starts automatically.

If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Care must be taken when opening the door, as steam will escape!

Change the programme in progress:

-Press the START button for about 2 sec., until the START indicator lamp switches off.

-Close the door.

-(Water drains for up to 60 seconds).

-Open the door.

-Select a new programme.

-Press the START button.

10.End of programme

11.Open the door, switch off the appliance

12. Turn off the water tap, unload the racks

At the end of the programme an acoustic signal will sound. The START indicator lamp switches off.

Press the OFF button. All the indicator lamps switch off.

Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.

2

3. HOW TO USE THE APPLIANCE

PROGRAMME SELECTION

Press the button

or to bring up the desired programme on the display. The appliance must be switched

on. If required, select options (if supplied). The corresponding indicator lamp switches on. Appropriate programmes and relative available options are detailed in table 1.1 on page 1.

Programme times stated in the table were obtained under normal conditions and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance's automatic calibration system.

HOW TO FILL THE DETERGENT DISPENSER

Only fill the detergent dispenser prior to starting a wash programme. Only use detergents specially recommended for dishwashers, observing the manufacturer's recommended dosage. Observe the manufacturer's safety warnings!

Open the detergent dispenser compartments by pushing the left button (button 1) of the dispenser.

a. Powder/gel/tabs

Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1.1).

Programmes without pre-wash:

pour the entire recommended dosage into compartment A. Programmes with pre-wash:

pour 2/3 of the recommended dosage into the large compartment A and 1/3 into the small compartment B.

Dishwasher tabs should be placed, according to the manufacturer's recommendations, in compartment A.

If the “Half load” option is selected, detergent dosage should be reduced by approximately 1/3.

b. Combined action detergents (2 in 1/3 in 1/... etc.)

Combined action detergents should be placed, according to the manufacturer's recommendations, in compartment A.

	Large				Small
		button 1
	compartment A				compartment B

Firmly close and press the detergent compartment lid shut after filling.

Detergents with rinse aid incorporated may be effective only with longer programmes. In the case of shorter programmes, detergent residue may be a problem (if necessary, use powder detergent). Detergents with rinse aid incorporated tend to form excess suds.

The guarantee is not applicable if faults are caused by the use of these products.

HOW TO CHECK/FILL/ADJUST RINSE AID

Not necessary when using a combined action detergent.

a. How to check the rinse aid level

Check the visual indicator C on the rinse aid dispenser: dark = sufficient rinse aid, clear = add rinse aid.

In the case of appliances with an electric indicator on the control panel, the rinse aid indicator lamp lights up red when rinse aid needs to be added.

b. How to fill the rinse aid dispenser

Open the rinse aid dispenser by pressing the right button (button 2) of the dispenser.

Fill the dispenser with rinse aid up to the “max” line (approx. 150 ml).

Shut the lid again.

Indicator C

max

button 2

Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault function of the appliance.

3