Whirlpool 4378876, 4378877, 4378878 Installation Instructions

Side-by-Side

Refrigerator l/4” Trim Kits

4370076,4370077,

and 4370070

Installation Instructions

Important

Do not discard dispenser trim or instructions.

Decorator Door Panel Installation Instructions

l/4” (6 mm) Panel Dimensions

Listed-below are required height x width dimensions for decorator panels. Panels are not supplied with this kit and can be purchased locally. Refrigerator panels should not weigh more than 30 pounds and freezer panels should not weigh more than, 15 pov& L

WI It-r t(

Refrigerator-Door Panel Upper Freezer Door Panel Lower Freezer Door Panel

b,iVldZn4 ICI-IL

63 3/32” x 19 310”

i a 3tw x i 3 3149’

31 9/l 6” x 13 3/4”

General

Electrical Shock Hazard Disconnect electrical power before installing panels. Failure to do so can result in death or electrical shock.

Personal Injury Hazard

Wear gloves and protect arms when handling trim pieces.

Failure to do so could result in cuts or other serious injury.

WARNING

Caution

To avoid property damage, protect soft vinyl or other

flooring with cardboard, rugs, or other protective material.

2. Dispenser Models Remove crushed/cubed ice switch cover on dispenser by placing taped edge of putty knife underneath cover and pulling out. Release bottom clips on dispenser

cover by placing taped edge of putty knife underneath cover and pulling out. Release top clips by holding bottom of dispenser cover out and sliding up.

3. Remove door handle inserts by placing screwdriver at

top of door handles in area between handle and insert and pulling forward. Pull edge of inserts forward along length of handles.

I I

’ I

Procedure

Important Save all screws and reuse in original location.

1. Remove top handle end caps by removing screws.

WARNING

Failure to do so could result in personal injury.

4. Remove door handles by removing screws.

Important Decorator panels should be cut to “l/4” panel dimensions. Refer to “l/4” Decorator Panel Dimensions” section.

Contents Decorator Panel Dimensions

Introduction Decorator Panel Parts

Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..-...

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..-..........................

Introduction

WARNING

Ekcttical Shock Hazard

Disconnect

Failure to do so can result in death or electrical shock.

Wear gloves and protect arms when handling trim

piSWS.

Failure to do so could result in culs or other serious injury.

Caution

To avoid property damage, protect soft vinyl or other flooring with cardboard, rugs, or other protective materlal.

Read entire manual before installing kit. Confirm all parts listed are included in kit. H parts are missing, contact source from whom kit was purchased.

lmporbnt

Mechanical experience is required to install trim kit.

9 Depending on installer’s knowtedge and skill,

installation can take from one to three hours.

Transfer food to an attemate cooling source. Check refrigerator warranty certificate for specific coverage. Warmty does not cover food loss.

Ensure trim surfaces are clean, dry and free of adhesive residue.

If unable to solve a problem during installation, contact source from whom kii was purchased.

electrical

power

before

Personal Injury Hazard

pieces

adhere property by confirming

installing Mt.

Listed below

decorator panels. Panels are not supplied with this kii

and can be purchased locally.

Caution

To avoid personal injury refrigerator panels should not weigh more than 30 Ibs (14 kgs) and freezer panels should not weigh more than 15 Ibs (7 kgs).

r/ #

RefrigeratorDoor ’ Upper Freezer Door

Lower Freezer Door

Parts List

1 Item 1

1 2

6 7 a Freezer

11 12 Top 13 1 Top Han& Cap,

15 Bottom Handle Cap, Freezer Door

1-1s r

are

required

\+AA.AIA&

height x width dimensions for

property damage,

014

61 15/16’x193/6 (1573 mm x 492 mm) 17 114’ x 13 34 (436 mm x 349 mm) 31 W16’ x 13 34’ (602 mm x 349 mm)

Description

Side Trim with l/5 Tape, Reftlgsrator and Freezer Door

Bottom Trim, Refrigemlor Door Battom Trim, Freezer Door Top Trim with l/16’ Tape, Refrigerator

Door Top Trim with l/16’ Tape, Freezer Door Trim, Diinser Retainer Handk Incerl, Reff$pmtor Door

Insed.

Fn#zer Door Sxew, Boltom Trim Bollorn Trim Spacer. Refrigeretor Door

Botlcm Ttim Spacer,

Handle Cap, ReMgsrator Door

Bottom Handle Cap. RettQerator Door

Installation InWuctions

Freezer Door

I Qty 1

2 ’ I

’ ! 1

1 !

2 I 1

I ’ I

1 1

I 1 I

Procedure

Important Save all screws and reuse in original location.

1. Remove top handle end caps by removing screws.

2. Remove cn~~hedkubed ice switch cover on dispenser by pulling forward. Release bottom clips on dispenser cover by placing taped edge of putty knife underneath cover and pulling out. Release top clips by holding bottom of dispenser cover out and sliding up.

3. Remove door handle inserts by placing screwdriver at top of door handles in area between handle and insert and pulling out. Pull inserts out along length of handles.

Remove end caps from bottom of handles by putting down. Install new bottom handle end caps by placing end caps in bottom of handles and snapping in place.

5. Install new handle inserts by placing insert on handles and snapping in place.

6. InstaY new top handle end caps by pladng on handles. Insert and tighten screws.

7. Replace dispenser cover by snapping in place.

Replace switch cover by snapping in p&e.

6. Remove toe grille by pulling fomard.

Caution

To avoid personal injury or property damage, temporarily tape doors shut.

9. Tape doors shut using masking tape.

WARNING

Electrical Shock Hazard Green ground wire must remain attached to hinge. Failure to do so can result in death or electrical shock.

10. Remove top hinge covers by removing screw% Trscs around lop hinges with a pencil. This helps alignment when reassembling. Unplug top hinge wire connectors. Do nof remove green ground wire

mm hinge. Remove top hinge screws.

wire conr#eto

wire wnnecton

11. Remove tape from refrigerator door. Qmsp refrigerator door securely and lift up while opening. This will free door from bottom hinge pin. Top hinge nUyCOfllBOffdOOK

+ 7 hidden pages