Welch Allyn Roll Stand User Manual

Installation Guide

Roll Stand Kit for Welch Allyn® 1500 Patient Monitor

The purpose of this guide is to:

1. Describe attachment of Utility Basket to Post (page 2).

2. Describe assembly of Post to Base (page 3).

3. Describe attachment of the Handle (page 3).

4. Describe attachment of Mounting Adapter to the monitor (page 4).

5. Describe mounting of the monitor (page 4).

6. Describe tilt and tilt tension adjustment (page 5).

Parts Reference

The following parts are provided for this procedure (hardware not shown):

Item # Description Qty

1 42” Offset Roll Stand Post with Mounting Plate 1
2 21” Roll Stand Base with 10 lb Counter Weight 1
3 Mounting Adapter 1

4 Handle with pre-installed hardware (2)10-32 x 9/16 PHMS 1

5* Basket with (2) Clips and pre-installed hardware 1

6 5/16-18 x 1” Hex Head Cap Screw (HHCS) 1
7 5/16 Split Washer 1
8 5/16 Flat Washer 1
9 M4 x 8mm Pan Head Machine Screw (PHMS) 4

10 5/32'' Hex Wrench 1

* Basket Clips have pre-installed hardware (2) 8-32 x 1-1/2'' PHMS, (2) 8-32 Hex Nuts.

Tools Required:

• Phillips screwdriver (not provided)

• 1/2" Socket Wrench (not provided)

• 5/32 Hex Wrench (provided)

3

4

5

2

1

WARNING: Do not reposition Handle or Basket higher on the Post than sho wn in this Guide. Any
additional accessory or components mounted on the Roll Stand Post could result in injury due to tipping
of the Roll Stand.

DU-WA-0014-60 Rev A 4/27/10 GCX Corp. Page 1 of 5

Attaching Utility Basket to Roll Stand Post

1. Install Basket Clips by inserting at an angle in center of basket and rotating each Clip until horizontal (below left). Slide
both Clips to top of Basket as shown (below right).

2. Slide Clips over bottom end of Post and move Basket to upper section of Post shown below. Installation Note: Basket

must be rotated to opposite side of Post when second section is reached as shown below left.

3. Slide Clips to top and bottom of Basket as shown below right. Using a Phillips screwdriver, tighten both Clips to secure
Basket on Post. Clip hardware (2) 8-32 x 1-1/2'' PHMS and (2) 8-32 Hex Nuts has been pre-installed.

Slide Lower Clip to

bottom of

Basket

DU-WA-0014-60 Rev A 4/27/10 GCX Corp. Page 2 of 5