VTech CS6229, CS6229-4, CS6219, CS6229-5, CS6219-4 User Manual 2
...
User’s manual
Accessory handset
for use with VTech models
CS6219/CS6219-2/CS6219-3/
CS6219-4/CS6228-3/CS6228-6/
CS6229/CS6229-2/CS6229-3/
CS6229-4/CS6229-5
w w w.v t e c h p h o n e s . c o m
Model: CS6209
Congratulations
T
Compatible with
Hearing Aid T-Coil
TIA-1083
on purchasing your new VTech product. Before using this telephone, please read
the Important safety instructions on page 7 of this manual.
This manual has instructions for setup and registration of your new handset. For
full instructions on using the handset, see the user’s manual that came with your
telephone base.
If you cannot nd your user’s manual, you can view or download it at
www.vtechphones.com.
For support, shopping, and everything new at VTech, visit our website at
www.vtechphones.com. In Canada, please visit www.vtechcanada.com.
The ENERGY STAR® program (www.energystar.gov) recognizes and
encourages the use of products that save energy and help protect our
environment. We are proud to mark this product with the ENERGY STAR®
label indicating it meets the latest energy efciency guidelines.
Telephones identied with this logo have reduced noise and interference
when used with most T-coil equipped hearing aids and cochlear implants.
The TIA-1083 Compliant Logo is a trademark of the Telecommunications
Industry Association. Used under license.
Table of contents
Getting started ................................... 1
Parts checklist ......................................1
Battery installation and charging .......... 2
Add and register a handset ..................3
Replace a handset ............................... 4
Handset layout ..................................... 5
Appendix ............................................. 6
Battery .................................................. 6
Important safety instructions ................ 7
Operating range ................................... 8
Maintenance .........................................8
About cordless telephones................... 9
The RBRC® seal ................................... 9
Warranty ............................................. 10
FCC, ACTA and IC regulations .......... 12
Technical specications ..................... 14
ii
Getting started
Parts checklist
Your telephone contains the following items. Save your sales receipt and
original packaging in the event warranty service is necessary.
Batte ry compar tm ent c over Batte ry
Handset
To purchase a replacement battery or a power adapter, visit our website at
www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to
www.vtechcanada.com or call 1 (800) 267-7377.
Charg er
1
Charg er adapt er
User’s manu al
Getting started
Battery installation and charging
Install the battery as shown below. After installing the battery, you might
be able to make and receive short calls. For best performance, charge the
handset for at least 16 hours before use. When not in use, place the handset in
the telephone base or charger. See page 6 for battery operating times.
Battery indicators Battery status Action
The screen is blank. Battery has no charge and
The screen shows
PLACE IN CHARGER
and ashes.
The screen shows
LOW BATTERY,
ashes, and the
handset beeps.
The screen shows
HANDSET X.
If the battery compartment cover is on the handset, press the indentation
1.
the handset cannot be
used.
Battery has very little
charge and the handset
cannot be used.
Battery has enough charge
to be used for a short time.
Battery is charged. To keep the battery charged,
and slide the cover to remove.
Plug the battery securely into the plug inside the handset battery
2.
compartment, matching the color-coded label.
Place the battery with the label THIS SIDE UP facing up and the wires
3.
inside the battery compartment.
Align the cover at against the battery compartment, then slide it towards
4.
the center of the handset until it clicks into place.
Charge the handset by placing it in the telephone base or charger. The
5.
CHARGE light is on when the handset charges.
1
2
3
Charge until the screen shows
LOW BATTERY (at least 10
minutes).
Charge until the screen shows
LOW BATTERY (about four
minutes).
Charge until the screen shows
HANDSET X (about one hour).
place it in the telephone base
or charger when not in use.
4
CHARGE light
5
When the screen shows LOW BATTERY, the backlight is off.
If the handset will not be used for a long time, disconnect and remove the
battery to prevent possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800)
267-7377.
2
Getting started
Add and register a handset
Each newly purchased handset (CS6209) must be registered to the
telephone base (CS6219, CS6228 or CS6229) before use. When rst
purchased, each expansion handset shows NOT REGISTERED.
To make registration easier, read all of the instructions on this page
before you begin. If the handset screen does not show LOW BATTERY or
HANDSET X, you will need to charge the handset for at least ve minutes
before registering to the telephone base.
To register a handset:
Place the unregistered handset in the telephone base or charger. If PRESS
1.
FIND HS 4 SEC ON BASE does not appear on the handset screen after
a few seconds, remove the handset and place it in the telephone base or
charger again.
On the telephone base, press and hold FIND HANDSET for about four
2.
seconds (until the red IN USE light on the
telephone base turns on) and then release the
button. The handset shows PLEASE WAIT...
and it takes about 10 seconds to complete the
registration. The handset shows HANDSET
X REGISTERED (X represents the handset
number assigned) and you hear a beep when
the registration completes.
When the registration is complete, the newly
registered handset is assigned the next available
handset registration number. For instance, if you
already have HANDSET 1 and HANDSET 2, the
next registered handset is HANDSET 3.
If the registration fails, the handset shows NOT REGISTERED. To reset the
handset, remove the handset from the telephone base or charger and place it
back in. Try the registration process again.
You cannot register a handset if any other system handset is in use.
Only one handset can be registered at a time.
3
Loading...