Ubiquiti UAPROE User Manual

UniFi Access Control Reader Pro

Model:

UA-Pro

System Components

UA-Pro

Note: Each UniFi Access component and all third-party

accessories are sold separately.

Installation Requirements

• Phillips screwdriver

• Ethernet cable, CAT5e or better

Sample Wiring Topology

Outside

PoE IN

Push

Motion
Sensor

Peripherals

Door Position

Switch

To PoE BT

Push

Button

Siren

External-Powered

Door Opener

UA-Hub

Magnetic Lock

UVC-G3-FLEX

UA-Pro

UA-Lite

UA-Lite

UA-Pro

UVC-G3 FLEX

Sample UniFi Access Diagram

Access Reader

Run an Ethernet cable from the UA-Hub location to the install
location of the access reader. Depending on your system setup,
the access reader can be installed on either the inside or the
outside of the door.

UA-Pro

1. Separate the UA-Pro from its mount by removing the security
screw from underneath the device.

2. Place the mount against the wall and use it as a template to
mark the area where the UA-Pro will be installed.

3. Use the marked area as a guide to cut a hole in the wall for
the mount.

4. Pull the Ethernet cable from the wall and feed it through the
mount.

5. Insert the mount into the wall and use the bottom clip to
adjust the camera mount, left or right, until it is level.

6. Secure the mount to the wall using two screws and remove the
level template.