Toshiba RAS-10 EKV-EE, RAS-10 EAV-EE User Manual [ru]

ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ

ENGLISH

PУССКИЙ

Кондиционер (сплит-система) для бытового использования

Внутренний блок

RAS-07, 10, 13, 16EKV

Наружный блок

RAS-07, 10, 13, 16EAV

1110255116

1110255116_EN.indd 1

2/13/13 2:47 PM

PRECAUTIONS FOR SAFETY

	● Do not install, repair, open or remove the cover. It may
	expose you to dangerous voltages. Ask the dealer or the
	specialist to do this.
0	● Turning off the power supply will not prevent potential
	electric shock.
DANGER	● The appliance shall be installed in accordance with
	national wiring regulation.
	● Means for disconnection from the supply having a
	contact separation of at least 3 mm in all poles must be
	incorporated in the fixed wiring.
	● Do not expose your body directly to cool air for a long
	time.
	● Do not insert your finger or any article into the air inlet/
	outlet.
	● When an abnormality (burning smell, etc.) occurs, stop
	the air conditioner and disconnect the power supply or
	turn off the breaker.
	● This appliance is not intended for use by persons
0	(including children) with reduced physical, sensory or
	mental capabilities, or lack of experience and knowledge,
WARNING	unless they have been given supervision or instruction
	concerning use of the appliance by a person responsible
	for their safety.
	● Children should be supervised to ensure that they do not
	play with the appliance.
	● Do not use any refrigerant different from the one specified
	for complement or replacement. Otherwise, abnormally
	high pressure may be generated in the refrigeration
	cycle, which may result in a failure or explosion of the
	product or an injury to your body.
	● Do not wash the unit with water. It may cause an electric
	shock.
	● Do not use this air conditioner for other purposes such as
	preserving food, breeding animal, etc.
	● Do not step or put anything on the indoor/outdoor unit. It
	may cause an injury or damage the unit.
	● Do not touch aluminium fin because it may cause an
0	injury.
	● Before cleaning the unit, turn off the main switch or the
CAUTION	circuit breaker.
	● When the unit won’t be used for a long time, turn off the
	main switch or the circuit breaker.
	● It is recommended that maintenance be performed by
	a specialist when the unit has been operated for a long
	time.
	● The manufacturer shall not assume any liability for the
	damage caused by not observing the description of this
	manual.

1 INDOOR UNIT DISPLAY

1 TIMER (Yellow)

2 OPERATION (Green)

3 RESET button

2 PREPARATION BEFORE USE

Preparing Filters

1. Open the air inlet grille and remove the air filters.

2. Attach the filters. (see detail in the accessory sheet).

Loading Batteries (when use wireless operation.)

1. Remove the slide cover.

2. Insert 2 new batteries (AAA type) following the (+) and (–) positions.

Remote Control Reset

1. Remove the batteries.

2. Press . 3. Insert the batteries.

3 AIRFLOW DIRECTION

1	Press	FIX	: Move the louver in
	the desired vertical direction.
2	Press	SWING	: Swing the air
	automatically and press again to
	stop.
3	For horizontal direction, adjust
	manually.

Note:

●Do not move the louver manually by others.

●The louver may automation positioning by some operation mode.

4 REMOTE CONTROL

1 Infrared signal emitter

2 Start/Stop button

3 Mode select button (MODE)

4 Temperature button (TEMP)

5 Fan speed button (FAN)

6 Swing louver button (SWING)

7 Set louver button (FIX)

8 Off timer button (OFF)

9 High power button (Hi-POWER) ! Economy button (ECO)

" Clear button (CLEAR)

# Check button (CHECK)

		1
	3	4
	2	6
	7
		5
	9
		!
	8
		"
	#

5 AUTOMATIC OPERATION

To automatically select cooling, heating, or fan only operation

1.Press MODE : Select A.

2.Press : Set the desired temperature.

3.Press FAN : Select AUTO, LOW , LOW+ , MED , MED+ , or HIGH .

6COOLING / HEATING / FAN ONLY OPERATION

1.Press MODE : Select Cool , Heat , or Fan only .

2.Press : Set the desired temperature. Cooling: Min. 17°C, Heating: Max. 30°C, Fan Only: No temperature indication

3.Press FAN : Select AUTO, LOW , LOW+ , MED , MED+ , or HIGH .

7DRY OPERATION

For dehumidification, a moderate cooling performance is controlled automatically.

1.Press MODE : Select Dry .

2.Press : Set the desired temperature.

8 Hi-POWER OPERATION

To automatically control room temperature and airflow for faster cooling or heating operation (except in DRY and FAN ONLY mode)

Press Hi POWER : Start and stop the operation.

1110255116_EN.indd 2

2/13/13 2:48 PM