INSTALLATION INSTRUCTIONS
HOODVENTILATORVM410
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
INSTALLATION MUST COMPLY WITH ALL LOCAL CODES.
IMPORTANT: Save these instructions for the Local Electrical Inspector’s use. INSTALLER: Please leave these Installation Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVETHESE INSTRUCTIONS
WARNING:TOREDUCE THE |
securely fasten a prominent warning |
|
RISK OF FIRE, ELECTRIC |
device, such as a tag, to the service |
|
SHOCK, OR INJURY TO PER- |
panel. |
|
SONS,OBSERVETHEFOLLOW- |
C. Installation work and electrical |
|
ING: |
||
wiring must be done by qualified per- |
||
CAUTION: FOR GENERAL |
||
sons in accordance with all applicable |
||
VENTILATING USE ONLY. DO |
codes & standards, including fire-rated |
|
NOT USE TO EXHAUST HAZ- |
construction. |
|
ARDOUS OR EXPLOSIVE MA- |
D. Sufficient air is needed for proper |
|
TERIALS OR VAPORS. |
||
combustion and exhausting of gases |
||
A. Use this unit only in the manner |
||
through the flue (chimney) of fuel burn- |
||
intended by the manufacturer. If you |
ing equipment to prevent backdrafting. |
|
have questions, contact the manufac- |
||
Follow the heating equipment manufac- |
||
turer. |
||
turers guideline and safety standards |
||
B. Before servicing or cleaning unit, |
||
such as those published by the National |
||
switch power off at service panel and |
Fire Protection Association (NFPA), the |
|
lock the service disconnecting means |
American Society for Heating, Refrig- |
|
to prevent power from being switched |
eration and Air Conditioning Engineers |
|
on accidentally. When the service dis- |
(ASHRAE), and the local code authori- |
|
connecting means cannot be locked, |
ties. |
E.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
F.CAUTION: To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces or garages.
G.WARNING – TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT WORK.
H.This appliance has a polararized plug (one blade wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
A.Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
B.Always turn hood ON when cooking at high heat or when cooking flaming foods.
C.Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
D.Use proper pan size. Always use cookware appropriate for the size of the surface element.
WARNING: - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
A.SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE
DEPARTMENT.
B.NEVER PICK UP A FLAMING PAN – You may be burned.
C.DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosion will result.
D.Use an extinguisher ONLY if:
1)You have a Class ABC extinguisher, and you already know how to operate it.
2)The fire is small and contained in the area where it started.
3)The fire department is being called.
4)You can fight the fire with your back to an exit.
PAGE 1
Loading...