Teradek 63102 XpressView Operators Manual

TERADEK, LLC

Entellus XpressView

Wireless Camera System

Instructions for Use

Rev 1.0

June 27th, 2016 Confidential Page 1 of 4

TERADEK, LLC

Introduction

The XpressView system is a wireless HD camera and receiver system. The system is
intended for use in a physician’s office, with an operator handling the portable wireless
camera system, while it is transmitting a wireless video signal to a receiver. The receiver
is connected to a video monitor via an HDMI cable.

Description

The XpressView system consists of two parts: a battery powered, portable camera with a built-in wireless video transmitter, and a wireless video receiver module.

Preparing your camera system

• Screw the lens coupler to the C-mount threads of the camera.

• Install the Endoscope probe into the coupler.

• Connect the LED light source to the endoscope light source connector.

• Connect the LED light source cable to the LED power connector on the side of

the camera.

• Slide the battery into the battery holder, and secure with battery clamp over

the back of the battery.

Hooking up the Receiver

• Connect an HDMI cable from the receiver module to the HDMI port on a high

definition monitor.

• Connect the barrel connector of the AC power supply to the 12V input on the

receiver.

• Place the receiver above the video monitor, using the hardware bracket

provided.

Powering up the devices

• Plug the receiver module’s AC power adaptor into a 110V outlet.

• Push the power button on the top of the camera module.

• Video will appear on the monitor within 10 seconds of powering up the

camera module.

• The LED’s on the receiver module are as follows:

June 27th, 2016 Confidential Page 2 of 4