Taylor C706 Specifications

Rockton, Illinois 61072

800-255-0626

Phone [phone] Fax [phone]

www.taylor-company.com

e-mail: [e-mail]

International Office
Taylor Company S.r.l.
Roma, Italy
Tel: [phone] Fax: [phone]
e-mail: [e-mail]

C706

Item No.

_______________________________

C706

Offer all the popular soft serve variations from low or non-fat
ice creams to custards, yogurt and sorbet.

Freezing Cylinder

One, 3.4 quart (3.2 liter).

Mix Hopper

One, 20 quart (18.9 liter). Simplified air/mix pump delivers the
precise amount of mix and air to the freezing cylinder for consistent
overrun. Separate hopper refrigeration (SHR) maintains mix below
41ºF (5ºC) during Auto and Standby modes.

Indicator Lights

Mix Low light alerts operator to add mix. When the Mix Out light
flashes, the unit shuts down automatically to prevent damage.

Electronic Controls

SoftechTMis our exclusive microprocessor based master control that
regulates refrigeration by measuring product viscosity to maintain
consistent quality.

Standby

During long no-use periods, the standby feature maintains safe
product temperatures in the mix hopper and freezing cylinder.

Digital Temperature Indicator

Hopper temperature is displayed to assure safe product
temperatures. Indicator may be switched from Fahrenheit to Celsius
temperature display.

Features

Soft Serve Freezer

Single Flavor, Pump

Continuing research results in steady improvements; therefore,

these specifications are subject to change without notice.

Optional Top Air
Discharge Chute

Optional Cart with

front opening

door

Optional Cart with
rear door for front

mount syrup rail

®

C706

C706Soft Serve Freezer

Electrical

One dedicated electrical connection is required. See the Electrical chart for
the proper electrical requirements. Manufactured to be permanently
connected. Consult your local Taylor distributor for cord & receptacle
specifications as local codes allow.

Beater Motor

One, 1.5 HP.

Refrigeration System

One, 9,500 BTU/hr. R404A. Separate Hopper Refrigeration (SHR), One, 400
BTU/hr. R134a. (BTUs may vary depending on compressor used.)

Air Cooled

Minimum 6” (152 mm) on both sides and place the back of the unit against a
wall to prevent recirculation of warm air. Minimum air clearances must be
met to assure adequate air flow for optimum performance.

Optional air discharge chute directs heated air exhaust upwards. No clearance
required on right side if air discharge chute is used.

Water Cooled

Water inlet and drain connections out rear panel 3/8” FPT. Provided with 4­1/4” (108 mm) legs, which increases height of unit.

Taylor Company,
A Division of Carrier Commercial Refrigeration, Inc.
Rockton, Illinois 61072
815-624-8333 800-255-0626 Fax [phone]

www.taylor-company.com

Printed in U.S.A.

)

Weights lbs. kgs.
Net 440 199.6
Crated 470 213.2

cu. ft. cu. m.

Volume 30.6 0.86

Dimensions in. mm.
Width 18-1/4 464
Depth 32-1/4 820
Height 34 864
Counter Clearance --- ---

*Designed to rest on a plastic pad directly on counter top.

Bidding Specs
Electrical: Volt ___________________ Hz__________ ph _________

Neutral:  Yes No Cooling:  Air  Water  NA

Options:_________________________________________________
_________________________________________________________

 Cart with casters-height to top of hopper cover: 59-1/8” (1502 mm)
 Cone Dispenser
 Decals - Vanilla or Flavor Burst Cone
 Hopper Locks
 Legs - [increase height of unit by 4-1/4” (108 mm)]
 Syrup Rail (front mount requires special cart with rear door)
 Syrup Rail Kit (side mount)
 Top Air Discharge Chute (air cooled only)

Options

Specifications

056745-ADV

7/08

Shown with optional Air Discharge Chute

C201 Cart Weights:

Net: 110 lbs. (49.9 kg) Crated: 143 lbs. (64.9 kg) 23.8 cu. ft. (0.67 cu.m)

Continuing research results in steady improvements; therefore, these

specifications are subject to change without notice.

Electrical Maximum Minimum Poles (P)

208-230/60/1 Air 35 26 2P 3W
208-230/60/1 Water 35 26 2P 3W
208-230/60/3 Air 25 19 3P 4W
208-230/60/3 Water 25 18 3P 4W
220-240/50/1 Air 30 24 2P 3W
380-415/50/3N~ Air 12 10 4P 5W

This unit may be manufactured in other electrical characteristics. Refer to the
local Taylor Distributor for availability.
(For exact electrical information, always refer to the data label of the unit.)

Fuse Size Circuit Ampacity Wires (W