Congratulations on the purchase of your new device.
CY
You have selected a high-quality product. The operating instructions are
part of this product. They contain important information on safety,
usage and disposal. Before using the product, familiarise yourself
with all handling and safety guidelines. Use the product only as
described and for the range of applications specified. Please also
pass these operating instructions on to any future owner.
Intended use
This appliance is intended exclusively for shaving and trimming
human hair.
This appliance is intended solely for use in private households.
Do not use it for commercial applications.
All other uses are deemed to be improper and may result in property
damage or even in personal injury.
Package contents
▯ Shaver with cutting unit
▯ Mains adapter
▯ Trimmer unit
▯ Protective cap
▯ Brush
▯ Charger
▯ Order card
▯ Operating instructions
2
SRR 3.7 C4
NOTE
Check contents for completeness and damage immediately
after unpacking. Contact Customer Services if necessary.
Description of the appliance
Figure A (front fold-out page):
Drive shaft
Cutting unit
Unlocking button
Protective collar
On/Off switch
Trimmer unit
Long hair trimmer
Input voltage: 5 V
Input current: 1000 mA
Battery: 3.7 V/800 mAh Li-ion battery
Environmental temperature: 5°C up to 35°C
Charging time: approx. 60 minutes
Operating time with fully
Input voltage: 100 - 240 V ∼ 50/60 Hz
Output voltage: 5 V
Input current: 0,2 A
Output current: 1000 mA
Protection rating: IP 20
Protection class: II /
4
SRR 3.7 C4
Safety instructions
DANGER – RISK OF ELECTRIC
SHOCK!
► Prior to use, check the appliance for visible
external damage. Never operate an appliance
that is damaged. There is a risk of electrocution.
► The appliance may no longer be used if there is
any damage to the cable, to the mains adapter,
the housing or any other components.
► Pull the mains adapter from the mains power
socket
— if a defect occurs,
— before cleaning the appliance,
— if you do not intend using the appliance
for long periods,
— after every use.
When doing so, pull the mains adapter itself
and not the cable.
► Never submerge the appliance or the cable
with mains adapter in water or other liquids.
GB
IE
CY
SRR 3.7 C4
5
GB
IE
CY
DANGER – RISK OF ELECTRIC
SHOCK!
► If the appliance drops into water, pull the mains
adapter out of the power socket before you
reach into the water.
► Never touch the mains adapter with wet hands,
especially when plugging it in or unplugging it.
Risk of electrical shock!
► Check the mains adapter and appliance regu-
larly for possible mechanical defects.
► Ensure that the cable does not get jammed in
cupboard doors or pulled over hot surfaces.
If this occurs, the cable insulation may be
damaged.
► The installation of a residual current circuit
breaker with a rated tripping current of no
more than 30 mA offers further protection from
electric shocks. Have the installation carried
out only by a qualified electrician.
6
SRR 3.7 C4
DANGER – RISK OF ELECTRIC
SHOCK!
► WARNING! Disconnect the main adapter from
handset when you clean it with water..
WARNING – RISK OF INJURY!
► This appliance may be used by children aged
8 years and above and by persons with limited
physical, sensory or mental capabilities or lack
of experience and knowledge, provided that
they are under supervision or have been told
how to use the appliance safely and are aware
of the potential risks.
► Children must not play with the device.
► Cleaning and user maintenance tasks may
not be carried out by children unless they are
supervised.
GB
IE
CY
SRR 3.7 C4
7
GB
IE
CY
WARNING – RISK OF INJURY!
► All repairs must be carried out by authorised
specialist companies or by the Customer Service
department. Improper repairs can pose significant risks to the user. It will also invalidate any
warranty claims.
► Do not use the appliance with a defective cutter
attachment or cutting length attachment, since
these may have sharp edges. There is a risk of
injury!
► Defective components must always be replaced
with original replacement parts. Compliance with
safety requirements can only be guaranteed if
original replacement parts are used.
► Only plug the mains adapter into an easily
accessible power socket so that you can pull
it out of the power socket quickly in an emergency.
8
SRR 3.7 C4
CAUTION – PROPERTY DAMAGE!
► Never operate the appliance unsupervised,
and only in accordance with the information
on the nameplate.
► For mains operation, use only the supplied
mains adapter (type PTB-050100BS).
► To avoid improper warming, do not cover the
mains adapter.
► The mains adapter is for indoor use
only.
GB
IE
CY
SRR 3.7 C4
9
GB
Charging the rechargeable battery with the
IE
charger
CY
The battery should be charged for at least 60 minutes before first
use.
NOTE
► Ensure that the appliance is switched off before charging the
battery.
1) Plug the connector 3 into the charging socket % of the charger.
Pay heed to the correct polarity: The guide pillar in the charging
socket % must grip the guide rail on the connector plug 3.
If it does not, the connector plug 3 cannot be inserted.
2) Flip open the charger 6 as far as it will go until the bracket is
in an upright position (see figure).
3) Plug the mains adapter ! into a mains socket that complies with
the appliance specifications.
4) Place the appliance in the charger 6. The bracket holds the
appliance in place in the charger 6.
The charging of the battery is indicated by the red flashing
symbol
9.
10
SRR 3.7 C4
As soon as the battery is fully charged, the red flashing symbol
■
disappears and the blue symbol
indicator appears.
■ Once the battery is fully charged, you can use the appliance for
around 60 minutes without connecting it to the power supply.
■ If the battery is nearly empty, the red symbol
of the battery charge
flashes.
Charging the rechargeable battery without
the charger
NOTE
► Ensure that the appliance is switched off before charging the
battery.
1) Plug the connector 3 into the charging socket - on the shaver.
Pay heed to the correct polarity: The guide pillar in the charging
socket - must grip the guide rail on the connector plug 3. If it
does not, the connector plug 3 cannot be inserted.
2) Plug the mains adapter ! into a mains socket that complies with
the appliance specifications.
The charging of the battery is indicated by the red flashing
symbol
■ As soon as the battery is fully charged, the red flashing symbol
indicator appears.
■ Once the battery is fully charged, you can use the appliance for
around 60 minutes without connecting it to the power supply.
■ If the battery is nearly empty, the red symbol
.
disappears and the blue symbol
of the battery charge
flashes.
GB
IE
CY
SRR 3.7 C4
11
GB
Cordless shaving
IE
CY
CAUTION! MATERIAL DAMAGE!
►
This appliance is not suitable for wet shaving!
This shaver can be used without the power cable. In this case, you
must charge the appliance before initial use (see section “Charging
the rechargeable battery with/without the charger”).
1) If not already attached, attach the protective collar from the
bottom onto the cutting unit (see fold-out page).
2) Fit the cutting unit with the attached protective collar onto
the drive shaft . Make sure that the protective collar is fitted
correctly onto the hand element.
3) Remove the protective cap 0.
4) Press the ON/OFF button . The symbol
charge indicator and the
as soon as the shaver starts up.
NOTE
► The best results are achieved if used on dry skin.
► It can take 2 to 3 weeks until the skin is accustomed to the
dry shaving system.
5) Move the shaving heads with straight and circular motions over
the skin.
6) After you have covered all the areas you want to shave, press
the ON/OFF button . The appliance stops. The display disappears at once.
7) Clean the shaver after every use with the supplied brush ..
For a more thorough cleaning, read the section “Cleaning and
care”.
12
of the battery
logo are displayed
SRR 3.7 C4
Shaving using the mains adapter
CAUTION! MATERIAL DAMAGE!
► This appliance is not suitable for wet shaving!
Should you wish to use the shaver without first charging the battery,
you can do so by using energy directly from the mains adapter !:
1) Plug the connector 3 into the charging socket - on the shaver.
Pay heed to the correct polarity: The guide pillar in the charging
socket - must grip the guide rail on the connector plug 3. If it
does not, the connector plug 3 cannot be inserted.
2) Insert the plug into a mains power socket.
The shaver can then be used.
Trimmer/long hair trimmer
To shape your beard, form sideburns or shave eyebrows, use the
trimmer unit .
1) Pull the cutting unit , if attached, off the handset.
2) Fit the trimmer unit onto the drive shaft (see figure).
GB
IE
CY
3) Attach the trimmer unit in such a way that both guide pillars
on the trimmer unit grip the guide rails on the drive shaft .
SRR 3.7 C4
13
GB
4) Press the ON/OFF button . The symbol
IE
CY
charge indicator and the
as soon as the shaver starts up.
5) When you have finished trimming, press the ON/OFF switch
again.
6) Clean the trimmer unit with the supplied brush ..
For a more thorough cleaning, read the section “Cleaning and
care”.
of the battery
logo are displayed
Travel lock
To prevent the appliance from switching on unintentionally, you can
lock the ON/OFF button .
♦ Press and hold down the ON/OFF button until the symbol
appears on the display.
If the ON/OFF button is pressed now, the symbol
appears briefly. The appliance however does not switch on.
♦ If you want to unlock your appliance again, press and hold
down the ON/OFF button :
– the symbol
5 seconds. The display then disappears and the appliance
can now be switched on again.
appears and starts to flash for approx.
14
SRR 3.7 C4
Cleaning and care
DANGER – ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect the power plug
from the mains power socket! There is a risk of electric
shock!
CAUTION! MATERIAL DAMAGE!
► Do not use abrasive, chemical or caustic cleaning agents
to clean this appliance. This will irreparably damage the
appliance.
Cleaning with the brush
Cutting unit
Clean the 3 shaving heads of the cutting unit after every shave
using the brush ..
1) Press the release button so that the cutting unit pops open.
2) Tap the cutting unit on a flat surface or blow off the hair
cuttings.
3) Use the brush . to remove any remaining hair cuttings.
Trimmer unit
■ Clean the trimmer unit after every shave using the supplied brush ..
■ Oil the long hair trimmer around every 6 months with a drop
of sewing machine oil.
GB
IE
CY
SRR 3.7 C4
15
Cleaning under running water
GB
IE
CY
The cutting unit is suitable for cleaning under running
water.
1) Pull the cutting unit off the handset.
2) Press the release button so that the cutting unit pops open.
3) Hold the cutting unit under the running water so that the
water flows through the shaving heads from the inside to the
outside.
CAUTION! MATERIAL DAMAGE!
► Ensure that only the shaver unit is under the stream of
water! The shaver handset is only protected against water
splashes and can be irreparably damaged if it is held under
running water.
4) Allow the cutting unit to dry out completely before using the
shaver again.
16
SRR 3.7 C4
Thorough cleaning
For a more thorough cleaning, remove the shaving heads:
1) Press the release button . The cutting unit pops up.
2) Overstretch the cutting unit a little so it can be pulled upwards
and off.
3) Carefully turn the lock marked with arrows in the direction of the
arrows until the mounting of the cutters allows itself to be lifted
off (see figure).
GB
IE
CY
4) Clean all parts under running water and then allow them to dry
fully.
5) Replace the cutting unit .
SRR 3.7 C4
17
6) To reattach, simply turn the lock marked with arrows in the opposite
GB
IE
CY
direction of the arrows so that the mounting of the cutters cannot
be lifted off.
7) Remove loose hairs from the shaver with the brush ..
8) Replace the cutting unit on the shaver. Ensure that it snaps
into place and is seated firmly.
■ Clean the housing and the mains adapter ! with a moist cloth.
NOTE
If...
– ... the shaving result is noticeably poorer, ...– ... you have to the shave the same spot repeatedly to
achieve a good result, ...
– ... the shave takes much longer than usual, ...– ... there is visible damage to the shaving heads, ...
... you must change the cutters.
Please contact Customer Services if you want to order cutters.
Storage
■ Always replace the protective cap 0 onto the cutting unit
when you are not using the appliance.
■ Store the everything in a clean, dust-free and dry place.
18
SRR 3.7 C4
Loading...
+ 49 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.