Seaga VC6000 Installation Manual

Operator’s Manual

Seaga Manufacturing, Inc.

700 Seaga Drive

Freeport, IL USA 61032

www.seagamfg.com

VC6000

Victory Series Snack Vendor

Victory Series Snack Vendor

VC6000

Coin Return
Button

LED Display

Display
Window

Keypad

Front
Door

Lock

Product Door

Bill Validator

Coin Return
Door

Coin Slot

The Victory Series Snack Vendor

INTRODUCTION

This manual is divided into two (2) main sections, Victory Series Snack Vendor, and Money Mechanisms.

LOCK

Your Victory Series Snack Vendor has one Lock, more commonly known as a "T" handle Lock. To unlock the Front Panel, insert
key and turn clockwise ¼ turn. When unlocked the "T" of the Lock will spring out from the vendor. Turn ¼ turn clockwise to open
Front Panel.

LEVELING

Once your vendor is in its new location, you will need to level it to insure proper operation. You will need a level. We recommend
a 3ft(1m) level, as it will give a more accurate reading than a small torpedo level. There are threaded Levelers attached to the
legs of your vendor that can then be adjusted up or down as needed.

ELECTRICAL

CONNECTION

The Victory Series Snack Vendor requires one (1) 120 VAC grounded outlet.

Victory Series Snack Vendor 120 Volts Less than 1 Amp

(Interior view with Front Door open)

Product Tray
(5 Select)

Product Tray
(10 Select)

Circuit
Board

Bill
Validator

Coin Return

Coin
Validator

Helix Coils

Vend Area

Anti-Theft Wall

KEYPAD AND LED DISPLAY

The Keypad is a touch sensitive operation. Light pressure will be necessary to activate each number or letter. The vendor's
Keypad is used by the customer to make their selection, and by the operator to set and test many functions of the vendor.
(Fig. 1)

The LED Display shows the customer the amount of money entered into the vendor, and the cost of their selection, it shows the
operator the Service Mode functions for setting and testing the various functions of the vendor.

1. To Access Operator Functions:
A.) Unlock and open the Front Door to access the Circuit Board, and enter Service Mode by pressing the

Red Service Mode Button. (Fig. 2)

(The following information is repeated, for your convenience, on a yellow sticker inside the vendor.)

SERVICE MODE

The Service Mode is entered and exited by pressing the Red Service Mode button on the Circuit Board. All Service Mode func­tions are cycled and selected by pressing the DOWN (↓) and UP (↑) keys. If no action is taken within 20 seconds the display
will return to Standard Operating Mode.

MOTOR COUNT("Cnt")-displays the total count of motors available in this vendor.

Enter Service Mode. Cycle through the Service Mode until the display reads "Cnt". Press any keypad character other

than the DOWN (↓) or UP (↑) key and the controller will display the motors it recognizes. The total number of motors should
equal the total number of selections.

BILL ESCROW("ES")-optional setting that when ON will return the bill to the customer on demand, when OFF the vendor will
return coins to the customer.

Enter Service Mode. Cycle through the Service Mode until the display reads "ES". Press any keypad character other

than the DOWN (↓) or UP (↑) key to turn this mode ON ("ES y") or OFF ("ES n").

MULTI-VEND MODE("UL")-optional setting that when ON allows more than one vend to be performed, provided there is still

Figure 1 Keypad Layout

Figure 2 Service Mode Button

Red Service Mode Button

(Circuit Board inside
Front Door)