Seaga SL1000 Installation Manual

Mechanical Vendor

Rev. 2012.02.27

Operator’s Manual

1

INTRODUCTION

Congratulations on the purchase of your new Mechanical Vendor. This vendor has been designed to give you many years of
dependable service. It requires little maintenance and is easy to set up and operate.

READ THIS MANUAL COMPLETELY

Your vendor is designed to operate simply and reliably, but t o take full advant age of your vendor, please read this owner’s
manual thoroughly. It contains important information regarding installation and operations, as well as a brief trouble­shooting guide.

EQUIPMENT INSPECTION

After you hav e received your vendor and have it out of the box, place it on a secure surf ace for further i nspection. Note:
Any damages that may have occurred during shi pping must be reported to the del ivery carrier immedi ately. Reporting
damages and the seeki ng of resti tut i on is the r espon sibi li ty of the equi pment owner. T he f act ory i s willi ng t o as sist you i n
this process i n any way possibl e. Feel free to cont act our Cu stomer Car e Departm ent with any que stions yo u may hav e
on this process.
Once your have your vendor located, we suggest that you keep t his manual for future reference, or you can view thi s
manual online at www.seagamfg.com.
is designed to help y ou quic kl y identify a problem and correct it.

Should any problems occur , ref er to the secti on entitl ed “t rouble-shooti ng gui de”. It

For Service and Cust omer Care:
8:30 a.m. - 4:00 p.m. CST. Mon thru Fri

815.297.9500

815.297.1758 Fax
email: c ustomerca re@seagamfg.c om

Seaga Manufacturing, Inc.

700 Seaga Drive

Freeport, IL 61032 U.S.A.

seagamfg.com

IM P ORTANT NOTICES

Your vendor is intended for indoor use only
Your vendor must be wall m ounted using appr opriate hardware f or the wall type (not included).
Always unload vendor before transporting it.
Remove the plastic c able ties from each helix coil.
Remove any protective sheets from under the helix coils befor e loading the vendor.
Do not load your vendor wit h disfigured or damaged product.

Rev. 2012.02.27

2

BRIEF DESCRIPTION OF YOUR VENDOR

Figure 1 - Overview

Display Wind ows

Locks

Coin Mechanism Knobs

Product window

Product Do or

Mechanism panel

Fron t Door

HOW TO LOCK & UNLOCK THE DOOR OF VENDOR

Your Vendor has 2 locks, one at the t op left and right of the front door (Fi g. 1). To open t he door, insert t he Key in the
locks and turn one-quarter rotation clockwise for right lock and counter clock wise for left lock. The door can now be
opened. The paper sheets under the hel ix coil s and th e cabl e ti es on each hel ix c oil m ust be rem oved bef or e loading t he
vendor.

MOUNTING

Your Vendor is m eant to be wall m ounted. For wall mounting, Four (4) Mounting Holes are prov ided on the back of the
vendor. The Hol es are 16” on center to mount to most wall studs (Fig. 2). A power drill, screwdriv er, level, ¼ inch dril l bit,
and mounti ng hardware will be required. Mounting hardware i s not provided, please use appropriate hard ware for your
wall type.

To Wall mount:
a.) Unlock and open the Front Door

b.) Determine, on the wall where vendor is to be mounted and mark where the

upper two (2) holes are to be located. (Fig. 2)

Figure 2 – Inside View

Wall Mounting Holes (4)

Rev. 2012.02.27

3