Rockwell Automation 1336 C User Manual

1336 Custom Option Label

Instructions

Description

Installation

A custom drive catalog option label has been included in this spare parts kit
to ensurethatan upgraded drive can be correctly identified as being custom.
The label must be installed if:

• A custom option is installed on a standard drive that previously did not

have this option. This is indicated by the absense of an “-MXxx” or
“-ENxxx” option specifier in the catalog string listed on the drive data
nameplate matching the custom control board.

The label can be discarded if this spare parts kit is an identical replacement
for a custom drive option already listed on the data nameplate catalog
string.

Nameplate Locations

The custom drive catalog option label should be installed near the existing
drive data nameplate.

1

Refer to drive user manual for frame reference classifications.

Nameplate Located on

Bottom Portion of

Chassis Behind Cover

Frames1 A1, A2, A3, A4

Nameplate Located on

Mounting Plate of

Main Control Board

ESC SEL

JOG

Frames1 B - G

2 1336 Custom Option Label

Custom Option Label Placement

Placement of the label after removal of the backing should be near the
upper-right corner of the drive data nameplate without touching or covering
any nameplate information.

Custom Option Label

-XXXX

VOLTS

OPTION

AMPS

CT VT

Ser x

PH HZ

Typical Drive Data Nameplate

1336x-xxxxx-xx-xx

AC Input
AC Output
DC Input

KVA

CT VT

Publication 1336-IN062A-EN-P – July, 2001 P/N 309393 (01)

Copyright © 2001 Rockwell Automation. All rights reserved. Printed in USA.