Philips FC 6842A Service Manual

Vacuum Cleaner

FC 6842/A

Service Information

Philips Domestic Appliances and Personal Care

Service Manual

PRODUCT INFORMATION

Type no. name : HR 68xx Triathlon (dry, wet and shampoo)

Versions : FC 6842 = blue Voltage : 230 V a.c. 50 Hz; 240 V a.c. 50 Hz Power : 1300 W (IEC) / 1500 W max. Air

displacement : 51 l/sec. measured without accessories Vacuum

(water col.) : 230 cm measured without accessories Noise level : 77 dB Capacity : Supply tank 3 litres (2)

Recovery tank 9 litres wet (7) Recovery tank 17 litres dry (7) Dust bag (HR 6947) 10 litres dry (39)

Cord length : 6.3 or 9.3 m (depends on the national version) Shampoo

system : Motorised pump Air exhaust : AFS-MICRO ﬁ lter FC 8032 Dimensions : 46 x 45 x 32 cm Net weight : 8.3 kg (without tools)

OPTIONAL

FC 8032 : AFS-MICRO ﬁ lters

4822 015 70056. Item 20 HR 6947 : Athena 8836 947 01000 = 4822 015 70058

Contains: 4 Paper dust bags, 1 motor ﬁ lter and 1 AFS-MICRO ﬁ lter. Items 29, 24 and 20

HR 6965 : Cleaning liquid for carpets 4822 390 80176

FC 8043 : Turbo nozzle FC 8042 : Twist and clean nozzle

SERVICE INFORMATION

Accessories:

See drawing for replacing of the shampoo pressure hose, for example the pistol handgrip.

Motor unit: The type no. plate is placed on the outside of the lower

housing (38). To open the motor unit, remove the inlay by pressing the inlay on the cord winder push-button and remove 2 screws (E). (The inlay is mounted on the cover by means of a snap construction). Use a long Philips screwdriver 9965 000 08332 to remove the 6 screws (F) of the lower housing / top housing. (Holes in lower housing are 13 cm deep). For safety reasons, make sure that the cap clamps do not come above the panel surface (31) after replacing of the switch (30). If the lower housing (38) must be separated from the top housing (15) always replace waterprooﬁ ng foam (22). Press hard on the housing during assembly of this unit to prevent the foam from moving during assembly.

This product meets the requirements regarding interference suppression on radio and TV.

After the product has been repaired, it should function properly and has to meet the safety requirements as ofﬁ cially laid down at this moment.

Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification

4322 277 00898 02/03

The cord winder lever (14) must be assembled through the top cover at an angle (as shown in the ﬁ gure) to operate the cord winder. Depending on the national version, the cleaner has a 6.3 or

9.3 m cord. The spring unit (101) is standard provided with a

9.3 m spring. To demount the cord winder use TORX screw driver no. T15, which is one of a set consisting of T20, T15, T10, T9, T8 and T6 4822 395 50145.

To check the shampoo circuit, it is neccessary to use the male plug (61) to open the valve in the female plug (32). If pos. 101 is replaced, shaft A must be lubricated with silicone grease (A). This grease may not be used on terminals (103) or on conductors (102).

Pos Description Service code

1 Supply tank cap 4322 005 13140 1a Male coupling of item1 4322 003 19630 2 Supply tank 4322 003 19730 4 Foam sleeve 4322 000 36710 5 Float assy 4322 005 13160 6 Clamp 4322 003 06240 7 Recovery tank compl. 4322 005 14620 8 Wheel compl. (stand.) 4322 009 05100 10 Caster arm 4322 007 29700 11 Diffusor 4322 003 09710 12 Shelter 4322 009 08000 13 Motor suppressor assy 4322 005 00100 14 Lever spring cord winder 4322 000 67530 15 Upper housing 4322 009 08020 16 Motor thermal fuse 4322 006 20180 17 Motor sealing / buffers 4322 009 08690 18 Motor 230 V 4322 009 05120 Motor 240 V 4322 009 05290 19 AFS ﬁ lter holder 4322 005 13130 20 AFS air ﬁ lter 4822 015 70056 21 Cord outlet 4322 009 05310 22 Waterprooﬁ ng foam 4322 000 36810 23 Pump vac. hose assy (stand.) 4322 009 05260 24 Motor safety ﬁ lter 4322 000 36750 27 Pump lamp 4322 006 22540 29 Cotton dustbag (opt.) 4322 004 92790 30 Switch unit 4322 009 08030 31 Panel 4322 005 13230 32 Speed coupler female 4322 005 00480 33 Fork washer 4322 000 67510 35 Term. plate unit 4322 005 00080 36 Pump shampoo 220 - 240 V 4322 009 06890 37 Pump press. hose assy 4322 009 08470 38 Lower housing 4322 009 08050 38a Sealing rim 4322 001 72460 39 Paper dustbags / ﬁ lters 8836 947 01000 40 Dustbag carrier 4322 005 13090 40a Dustbag lock 4322 003 05120 41 Sealing rim 4322 001 73120

Pos Description Service code

51 Nozzle D272 (opt.) 4822 479 30138 52 Strip of nozzle (opt.) 4822 479 20039 53 Fluff. coll. (opt.) 4822 479 20038 54 R & C nozzle 4322 004 22490 56 Furniture brush 4322 004 22570 57 Crevice nozzle 4322 003 19920 58 Small nozzle 4322 004 22560 59 Clip 4322 003 19900 60 Bend and ﬂ ex tube 4322 009 08060 61 Speed coupler male 4322 002 22530 62 Clamping bush (stand.) 4322 003 19760 63 Tube leaf spring 4322 007 16000 64 Valve pistol complete 4322 004 22800 65 Shampoo hose (l = 215) 4322 003 14920 66 Wet sweep nozzle 4322 004 22780 67 Mopper of wet sweep nozzle 4322 004 22790 68 Mopper replacement set 4322 009 05280 69 Tube clip 32 4322 003 19930 70 Female plug 4322 003 19770 71 Mini wet sweep 4322 003 17820 73 Suction tube (pvc) (opt.) 4322 004 22820 Suction tube (stainl. steel) 4322 004 41180 74 Tube coupling bush 4322 001 99120 75 Tube coupling spring 4322 007 45550 76 Washbag window cleaner 4322 004 93270 77 Wiper window cleaner 4322 003 13880 78 Window cleaner assy 4322 004 22810 79 Connection hose assy 4322 005 13120 101 Reel half spring unit (l=9 m) 4322 009 07940 102 Reel half contact unit 4322 009 07950 103 Contact ring plate 4322 009 07960 104 Brake tyre 4322 001 72360 107 U.K. / H.K. L= 9.3 m 4322 006 01720 108 Euro 4.8 mm pins L= 9.3 m 4322 006 01410 109 Swiss L= 9.3 m 4322 006 01670 110 Italy L= 9.3 m 4322 006 01460 111 Cord winder draw rod 4322 001 98540 A Silicon grease for the shaft 5322 390 20011 B Screw 3.5 x 12 / T10 4322 002 82550 Cleaning liquid 8836 965 01010

+ 3 hidden pages