Olympus KV-6 Instructions For Use Manual

Specification

Classification
(electromedical
equipment)

Regulatory status European Economic Area

Dimensions and weight Dimensions Height: 210mm Width: 305mm Depth: 375mm

Power switch Marking The power switch is marked . A white LED in the center signalizes it is turned on

Power requirements Power supply 100-240 V~ Fusing 2 x T1.6 AH Marking: The mark ~ on

Environmental
conditions

Fluid Ingress In accordance with EN IEC 60601-1/UL 60601-1, the product is marked IP21 to indicate that it is provided with an enclosure that prevents entry of such an amount of

Resistance to
chemicals

Pump specification Nominal vacuum: 95 kPa Nominal free air flow rate: 50 l/min, adjustable to 40 or 60 l/min.

Thermal cut-out The temperature is observed by a sensor in the housing. If the temperature in the housing exceeds 80 °C (176 °F), the software stops the motor and turns on the yellow

Single use suction liner To prevent fluid from being drawn up to the pump the single use suction liner contains a mechanism to shut off the flow when the liner is overfilled. This mechanism is

Suction jar The suction jars can be autoclaved up to 135 ºC or disinfected. The jar is impact resistant.

Suction jar lid The suction jar lid clips and where applicable the float mechanism, are autoclavable up to 135 ºC. The inlet connection (from the endoscope) is marked with the word

Tubing Use only tubing specified in the KV-6 Instructions for Use, otherwise equipment malfunction may result.

Vacuum gauge Range: 0 to 100 kPa Accuracy: ±2.5%

Standards compliance Complies with EN ISO 10079-1 and EN IEC 60601-1 and UL 60601-1

Electro-magnetic
Compatibility

Type of protection against
electrical shock

Degree of protection
against electrical shock

Degree of protection
against explosion

Mode of operation Continuous

(EEA)

Weight 9.3 kg

Frequency 50/60Hz Power rating 120 W

Ambient Temperature Operational: +5ºC to +40ºC (+41ºF to +104ºF)

Relative humidity Operational: 30-75 %

Atmospheric pressure Operational/Storage: 70.0 to 106 kPa

falling liquid as might interfere with its safe and satisfactory operation when correctly positioned.

The external surfaces of the Olympus KV-6 are resistant to: 2% aqueous neutral detergent, 70% ethyl alcohol, isopropyl alcohol, water.

In accordance with ISO 10079-1, the unit is marked with the words ‘HIGH VACUUM, HIGH FLOW’ to indicate it has a vacuum of at least 60 kPa in 10 seconds and a
free air flow rate of 20l/min or greater.

LED. It is possible to restart the motor again as soon as the temperature in the housing drops below 70 °C (158 °F).

activated when contact is made with aspirated fluid.

PATIENT, the outlet connection (to the pump) is marked with the word VACUUM.

This product complies with the requirements of EN IEC 60601-1-2 for emissions and immunity, and as such, its operation is unlikely to
be affected by, or cause interference with, equipment meeting appropriate EMC standards. As a precaution, equipment which may be
sensitive to interference outside the limits specified by EN IEC 60601-1-2 should not be placed in close proximity to the KV-6.

Classification according to EN IEC 60601-1 / UL 60601-1: Class 1 with Type CF applied part.

In accordance with EN IEC 60601-1 and UL 60601-1, the KV-6 is marked with the symbol to indicate the provision of an adequate
degree of protection against electrical shock and that it has an applied part isolated from all other parts of the equipment.

None: the Olympus KV-6 must NOT be used in the zone of risk of flammable anaesthetic gases.

CE This mark on the product indicates compliance with Directive 93/42/EEC relating to medical devices, Class IIa.

the product indicates the
requirement for an AC
power supply

Storage: -20ºC to +50ºC (-4ºF to +122ºF)

Storage: 20-95%

SUCTION PUMP

KV-6

OLYMPUS KEYMED

KeyMed House, Stock Road, Southend-on-Sea,
Essex SS2 5QH, United Kingdom
Telephone: [phone] Fax: [phone]
e-mail: [e-mail] www.keymed.co.uk

sales and distribution locations visit:

For a complete listing of

www.olympus.com

Printed in UK PL022/201505

SUCTION PUMP

2

2

2

2

2

2

KV-6

The KV-6 Suction Pump is the successor to the KV-5 pump. It is designed for endoscopic aspiration and for non­endoscopy applications. The unique flow change buttons allow a fast vacuum build-up with a single touch. It has a 'whisper
mode’ for quiet operation and ‘turbo mode’ for faster suction. The pump connects to an extensive fluid collection system.

Key Benefits

• High Suction Performance

The KV-6 suction pump has vacuum capabilities of up to -95kPa. There are three pre-set speed settings (40l/min, 50l/
min and 60l/min), which enables the operator the flexibility to control the rate of vacuum build-up at a touch of a button.

• Cleaning and hygiene

– Single use collection system allows easy and safe disposal of clinical waste.
– Touch sensitive buttons are easy to clean.
– Disposable bacterial and odour filters.

• Compatibility

Compatible with existing KV-5 accessories and Olympus workstations.

It is ideal for use either mounted on a procedure trolley or as a stand-alone unit. The variable suction control allows
adjustment to meet individual requirements. A high performance pump and motor combination ensure that the unit is
‘whisper quiet’ for any working environment.

Accessories Overview

Suction tubing Patient connecting tubing

K10026130
with 2 coupling
pieces (1 x 90),
7 x 12 mm,
60 cm

Disposable Liners

K10021894
K10021895

1.5 Litre

Jars for Liners

K10021893

1.5 Litre

Filters

K10026804
with 2 coupling
pieces,
7 x 12 mm,
60 cm

K10021897
K10021898

2.5 Litre

K10021896

2.5 Litre

K7505195
MAJ-103,
5 pack
K7503432
50 pack

Reusable Lids

Reusable Jars

K10026127

0.25 Litre

K7505595
(USA only)
50 pack

K7503760
1 & 2 Litre

K10026128

0.25 Litre
K7503762
1 Litre
K7503763
2 Litre

The KV-6 may be adapted to suit individual requirements by the use of optional components, to allow a single-use or
reusable suction system. The single-use liners are conveniently supplied with solidifier for safe and simple use and disposal.

Product Details

Compact design for convenient use

The KV-6's compact and easy-to-use design means that is
suitable for use in office space or the operating theatre.

Simple and easy to operate with clearly labelled
controls

A clear control panel ensures that the KV-6 suction pump
can be used safely and efficiently by all staff.

Trolley mountable for convenience

The KV-6 is ideal for use either mounted on a procedure
trolley or as a stand-alone unit for maximal flexibility of use.

Use with 1.5 or 2.5 litre jars and liners

Flexibility to use the KV-6 with either 1.5 or 2.5 litre jars and
enables its use in a variety of procedures.

Suction jar mountable on Olympus workstations

Ensuring that the suction jar can be mounted on Olympus
workstations allows compatibility with the Olympus range of
devices and equipment for the office or operating theatre.

Microbial and Odour filter for safe suction

Microbial and odour filters ensures that the fluids suctioned
are non-contaminated for maximal safety.

K10027321
Disposable
bacteria /
odour filter
10 pack

K10027322
Disposable
bacteria filter
10 pack

Clamp Holder Two or more jars

Disposable collection system Disposable / reusable collection system

K10021793

K10002819
MAJ-191

MAJ-1659
K10001115
MAJ-190

K7503556
WM-60 / D-60

K10021885
MAJ-1673

K10021188
10 Pack

K10021878
MAJ-1672

K10026130

K10026127

K10026128

K10021882
MAJ-1674