Logitech 970114-0403 - X 530 5.1-CH PC Multimedia Home Theater Speaker Sys, X-530 - 5.1 Surround Sound Speaker System, X-530 Setup & Installation

Setup Installation Instalación
Logitech
®
X-530
1. Subwoofer
2. Rear right speaker — black plug
3. Rear left speaker — yellow plug
4. Audio input cable to PC — green, black & orange plugs
5. Front right speaker — d-sub connector
6. Power cord
7. Front center speaker — red plug
8. Front left speaker — white plug
9. Subwoofer volume
About your Logitech® X-530 speaker system
2
English
Safety
1
English
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Unplug the speakers from the computer and from the electrical outlet before cleaning them with a dry cloth.
• Install in accordance with the manufacturer’s instructions.
• Place the speakers in a stable location so they will not fall causing damage to the speakers or bodily harm.
• Do not use the speakers near water, and do not immerse them in any liquid or pour any liquid on them.
• Do not block the openings in the speaker cabinets, never push objects into speaker vents or slots because of fire or electric shock hazards, and provide sufficient space around the speakers for proper ventilation.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Do not defeat the safety purpose of the polarized plug. A polarized plug has two blades with one wider than the other. The wide blade is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
• Operate the speakers only from the low level audio line out jack of the computer or of an audio device.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
• Only use attachments/accessories specified by the manufacturer.
• For added protection during lightning storms, unplug the speakers from the electrical outlet and turn off the computer.
• Unplug this apparatus when unused for long periods of time.
• Servicing is required when the apparatus has been damaged in any way, such as when the power-supply cord or plug has been damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
• Refer all servicing to qualified service personnel.
• The speakers should be disconnected from the mains by placing the power/standby switch in the standby position and unplugging the power cord of the speakers from the AC mains receptacle.
• The socket-outlet shall be installed near the equipment and shall be readily accessible.
• Do not place any form of open flame source, such as lighted candles, on the apparatus.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS
TO RAIN OR MOISTURE.
IMPORTANT SAFETY INFORMATION
CAUTION
ELECTRIC SHOCK HAZARD
A. Headphone jack B. System volume knob C. Power light D. Power/standby button
A
C
B
D
SUB
VOLUME
REAR RIGHT
REAR LEFT
FRONT LEFT
FRONT
CENTER
FRONT RIGHT
1
7
3
2
6
5
8
9
4
Setting up your Logitech® X-530 speakers
Important: For your safety, set up the system before plugging it into a power source.
1. Before attaching the cables to the subwoofer, position the two front satellite speakers on either side of your computer monitor about the same distance from each other as from you. Angle them to face you. The right front speaker is the control center for your system, so you will want to place it within easy reach. Place the rear left and right satellite speakers behind you and about the same distance apart as the front speakers. Position the front center channel speaker on top of your monitor or on your desk in between your monitor and keyboard. Depending on where you place your speakers, adjust the stand to direct the sound toward you.
For best sound quality, place the subwoofer on the floor beneath your desk. Be sure to maintain at least 6 inches of spacing around the subwoofer to allow for adequate ventilation.
2. Insert the colored plug from each satellite speaker into the corresponding colored jacks on the back of the subwoofer. Connect the d-sub plug from the front right speaker to the subwoofer as shown on the previous page. Carefully align the pins before inserting the plug, and screw down the connector.
3. A. If you have a PC and a:
• 6, 7 or 8 channel (5.1, 6.1 or 7.1) sound card: Connect all 3 colored plugs from the audio input cable to the color­coded jacks on the sound card.
1. If jacks on your soundcard are not color coded, plug the audio input as follows:
• green to front L/R (or #1)
• black to rear L/R (or #2)
• orange to center / sub (or #3)
• 4-channel sound card: Connect the green plug from the audio input cable to your sound card’s front jack and the black plug to your sound card’s rear jack. Do not use the orange plug.
• 2-channel sound card: Connect the green plug from the audio input cable to the “line out” jack on your sound card. Do not use the black or orange plugs.
With a 2-channel sound card you will not hear sound from the rear speakers.
B. If you have a video game console (PlayStation®, PlayStation®2, Xbox™, or GameCube®):
• Connect the green, black and orange plugs from the audio input cable to the 3 stereo mini jacks on the video game adapter.
• Connect the red and white RCA audio cables from your video game console to the RCA audio jacks to the video game adapter.
4. Plug the subwoofer’s power cord into an electrical outlet.
Enjoying your Logitech® X-530 speakers
Access these controls on the right front speaker:
Power/Standby
Toggles between power on and standby mode.
System Volume
Adjusts the overall system volume.
Headphone Jack
When headphones are used with your X-530 system, the speakers will mute automatically for private listening. Headphone volume is controlled by the soundcard on your computer.
Dolby® Digital
The X-530 speakers support Dolby® Digital sound on your PC if your 6-channel or greater sound card or DVD software can decode a Dolby® Digital soundtrack.
Subwoofer Volume
Located on the subwoofer. Use to adjust subwoofer volume (bass level).
Mounting your speakers to the wall
Your Logitech X-530 speaker satellites are wall mountable. Swivel the satellite base to desired position, and use the notch to hang your speaker on appropriate wall anchors.
Specifications
• Total RMS Power: 70.1 Watts Subwoofer: 25 watts RMS into 4 ohms at 100Hz at 10% THD clipping (total harmonic distortion) Satellites: 45.1 watts RMS (2 x 7.4 w Front; 15.5 w Center: 2 x 7.4 w Rear ) into 4 ohms at 1 kHz at 10% THD clipping (total harmonic distortion)
• Total Peak Power: 140 Watts at <10% THD
• System THD: Better than 0.07% THD before
clipping
• Signal to noise ratio: >99 dB
• Frequency response: 40 Hz - 20 kHz
• Driver Size: 2” high excursion satellites, 5.25” high excursion subwoofer
• Speaker dimensions: Satellites: (H) 8” x (W) 2.5” x (D) 3” Center: (H) 2.5” x (W) 8” x (D) 3” Subwoofer: (H) 11.5” x (W) 6” x (D) 9.25”
Setup
Setup - Operation - Specifications
4
English
3
English
Notch
Loading...
+ 7 hidden pages