Kyocera FS-3040P, FS-3540, FS-3040, FS-3140P, FS-3140MFP Service Bulletin 2LW 010

Service Bulletin

SB Number:

Subject:

SB 2LW-010

Zigzag ruled lines in the sub-scanning direction

Creation Date: 18/11/2011

Model: FS-3040MFP/3140MFP/3040MFP+/3140MFP+/3540MFP/3640MFP

Phenomenon Zigzag ruled lines may appear in the sub-scanning (Vertical) direction.

Cause This is due to contact failure between the heat roller bearing and the ground plate of the

Fuser unit.

Solution The ground plate (Plate earth fuser) has been changed as follows:

1. The material has been changed (Hardened) from SUS 304CSP1/2H to SUS 304CSPH

2. The shape (Angle) has been changed.

Abnormal image sample

There should be no gap between the
heat roller bearing and the ground plate of the
Fuser unit.

Old condition

Bearing

New condition: The angle has been changed
to improve the contact with the bearing.

45°

25°

5°

KMIS Service Department, Kyocera Mita Europe B297 / SB 2LW-010

Page 1 of 2

Parts

Service Bulletin

No. Old Parts

No.

1 302J193051

2J193051

2 302F925211

2F92511

Classication

Field measure When the above mentioned phenomenon occurs, please replace the ground plate of the Fuser

Serial numbers of affected machines

Type Serial number

FS-3040MFP/3140MFP/3040MFP+/3140MFP+/3540MFP/3640MFP August 2011 production.

The above mentioned changes have been applied to machines produced after the above mentioned production date.

New Parts
No.

302J193052
2J193052

302J025370
2J025370

Entire stock rework

unit (Plate earth fuser) with the latest type.

Description Q’TY Interchange-

FK-350(E) 1 1 X O

+PLATE EARTH FUSER 1 1 X O

In-eld modication at next visit

In-eld modication by case

X

ability

Old New Old New

No modication necessary

KMIS Service Department, Kyocera Mita Europe B297 / SB 2LW-010

Page 2 of 2