Kyocera FS-2100, FS-4100, FS-4200, FS-4300 TroubleShooting
FS-4100DN, FS-4200DN, FS-4300DN
TROUBLESHOOTING GUIDE
Top tray paper full detection
(Based on Service Bulletin 2LV-0002-C291)
KDE PRODUCT ENGINEERING
FS-4100DN, FS-4200DN, FS-4300DN
TROUBLESHOOTING GUIDE
Top tray paper full detection
INDEX PAGE 2
This document was developed as a support document and in no way replaces any service manuals or bulletins we may otherwise produce Information contained in this document is
believed to be accurate at the date of publication but it is not guaranteed that such information is accurate at the date of receipt or will remain so in the future.
Please note the legal instructions on the last page!
Describtion & Cause Page 3
Corrective measures Page 4
Field Measure Page 6
Serial numbers of Affected Machine Page 7
Appendix Page 10
TASKalfa-XYZ Troubleshooting Guide 2
FS-4100DN, FS-4200DN, FS-4300DN
TROUBLESHOOTING GUIDE
Top tray paper full detection PAGE 3
Description:
Although the paper have not been full on the top tray, the message “Top tray is full of
paper. Remove the paper” may be displayed.
Cause:
If strongly pressing with hand or the bundled items the actuator (302LV2814_) switching
the eject full sensor toward the exit frame side (Arrow A direction in the figure next page)
when packing the machine, the sponge (X) may be fallen between the ribs (Y). As a result,
the sensor light interruption of the actuator that overruns toward the eject frame side
may be out of the detectable range of the eject full sensor and the top tray paper full may
be mistakenly detected.
(Based on Service Bulletin 2LV-0002-C291)
3
Loading...