Karcher BR30-4C User Manual
QUICKSTART
BR 30/4 C
Start up
Warning
These are only brief instructions! Please read and comply with these instructions prior to using or servicing your
appliance.
The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers
for the operator and other persons.
1
A
D
B C A Remove the fresh water reservoir from the
appliance.
B Open the cover of the fresh water reservoir.
C Pour in water/detergent mixture. Maximum
temperature of the liquid 50 °C.
Close the cover of the fresh water reservoir.
D Insert the fresh water container into the
appliance.
2
A B A Swivel bottom cable hook upward and
remove cable.
Check mains cable and plug for damage or
breakage. Get them replaced only through
customer service agent or an electrician.
B Connect the mains cable.
5.964-028.0 11/12
QUICKSTART
Operation
1
A
C
B
D
Normal soiling
Danger
Risk of injury on account of electric shock caused
by a damaged mains cable. Do not let the mains
cable come in contact with the rotating brushes.
Caution
Risk of damage to the floor covering.
The cleaning method for severe soiling must only
be used on floors suitable for this kind of
cleaning.
Risk of damage to the fresh water pump if it runs
dry because of empty fresh water reservoir.
Monitor the fill level indicator and switch the water
pump switch off if the fresh water reservoir is
empty.
A Bring the vacuum bar lifting pedal into the
"vacuuming" position.
B Press the park position release and swivel
the handle toward the rear.
C Set main switch for brush/vacuum operation
to “1”.
D Activate the water pump switch.
Move the appliance over the surface to be
cleaned.
2
1
A B Severe soiling
Caution
Risk of damage to the floor covering. The cleaning method for severe soiling must only be used
on floors suitable for this kind of cleaning.
A Set the vacuum bar lifting pedal to the "not
vacuuming" position and perform cleaning as
with normal soiling.
The detergent liquid remains on the surface
to be cleaned and has time to react
B Move the vacuum bar lift pedal to position
"suction off" and reclean the surface.
Finish operation
A
B C
Complete cleaning
A Turn off the water pump switch.
Push the appliance a little further to
vacuum up the remaining water.
B Set main switch for brush/vacuum
operation to “0”.
C Swivel the appliance handle forward
and arrest in the park position.
D Pull out the mains plug.
D
5.964-028.0 11/12
Loading...