Jaguar XJ8 2009 User Manual

MODEL

S-TYPE, XJ

DATE

30 JUNE 2009

NUMBER

JTB00114

(Issue 2)

Service

TECHNICAL BULLETIN

ISSUE '2' CHANGES ARE HIGHLIGHTED WITH GRAY BACKGROUND

SECTION: 501

Rear Windshield Blind Motor / Arm Mechanism - Lower Level Service Part Availability

AFFECTED VEHICLE RANGE:

S-TYPE (X200) VIN: M45255 - N90324

Model Year: 2003 - 2008

XJ (X350) VIN: G00442 - H32692

Model Year: 2004 - 2009

CONDITION SUMMARY:

Situation: The rear windshield blind motor and arm mechanism are now available as separate serviceable parts. In the event of one of the following conditions, replacement of the complete rear windshield blind assembly is no longer necessary:

• Rear windshield blind motor failure

• Rear windshield blind arm mechanism failure

Action: In the event of a customer concern of one of the above conditions, follow the Repair Procedure outlined below to replace the rear windshield blind motor or arm mechani sm.

PARTS:

C2C 40233...............Rear windshield blind motor kit Qty: 1

C2C 40234...............Arm mechanism kit (XJ) Qty: 1

XR8 57992 ...............Arm mechanism kit (S-TYPE) Qty: 1

TOOLS:

Refer to Workshop Manual (GTR) for any special tools (if required)

WARRANTY:

NOTE: Repair procedures are under constant review, and therefore times are subjec t to change;

those quoted here must be taken as guidance only. Always refer to DDW to obtain the lates t repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Description SRO Time

Condition Code Causal Part

(hours)

Rear windshield blind motors - Renew (XJ) Rear windshield blind motors - Renew (S-TYPE) Rear windshield blind arm mechanism - Renew (XJ) Rear windshield blind arm mechanism - Renew (S-TYPE)

86.56.82

76.14.30

2.00

1.10

2.00

1.00

C2C34877SEL JLM21092LEG C2C34877SEL JLM21092LEG

Normal warranty policy and procedures apply.

NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicle s, or provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not a Dealer, do not assume that a condition described affects your vehicle. Contact an authorized Jaguar service facility to determine whether this bulletin applies to a specific vehicle.

NUMBER

TECHNICAL BULLETIN

JTB00114

(Issue 2)

REPAIR PROCEDURE:

REPLACE REAR WINDSHIELD BLIND MOTORS

NOTE: Global Technical Reference (GTR) lookup sequence is as follows: GTR Home > NAS > Model > Service Information > Model Year > Workshop Manual > 5: Body and Paint > 501: Body and Paint > 501-05: Interior Trim and Ornamentation

1. Refer to Workshop Manual (GTR) Section 501-05: Interior Trim and Ornamentation to replace the affected rear windshield blind motors.

REPLACE REAR WINDSHIELD BLIND ARM MECHANISM

1. Refer to Workshop Manual (GTR) Section 501-05: Interior Trim and Ornamentation to replace the affected rear windshield blind arm mechanism.

Page 2 of 2