HP Photosmart C5140, Photosmart C5150, Photosmart C5180 Setup Guide

Start Here

USB cable users: Do not connect the USB cable

1

Use this guide to set up the hardware and connect the HP All-in-One to either your computer or a working
network. If you have problems during setup, see Troubleshooting later in the guide.

2

ab

Remove all tape and lift display

until step A2.

a Remove all tape and protective fi lm from

the lid and from the front and back of the
device.

b Lift the color graphics display and remove

the protective fi lm. You can adjust the
height of the display to a position suitable
for viewing.

3

Windows CD

Mac CD

Documentation CD

This CD may be
included for some
languages where help
is not available through
the software.

Locate components

HP Photosmart C5100 All-in-One series

Basics Guide

Basics Guide

adapter

power cord

4 x 6 in
(10 x 15 cm) photo paper

control panel faceplate
(may be pre-attached)

ink cartridges

USB cable*
*Purchased separately

Ethernet cable*
*Purchased separately

The contents of your box may differ
Additional network equipment

specifi ed later in the guide.

HP Photosmart C5100 All-in-One series Setup Guide

4

h

.

m

c

Attach the control panel faceplate
(if not attached)

a

a Position the control panel faceplate

over the buttons on the device.

5

Main tray:

abc

Load paper into both trays

b

b Press down fi rmly on all edges of t

overlay to secure it. Make sure all
buttons are visible and not blocked

d

Load plain white paper in the bottom paper tray. Plain paper is needed for alignment.

Photo paper tray:

e

e Lift the output tray. f Pull out the photo tray. g Load the 4 x 6 inch (10 x 15 c

h i

f g

photo paper from the sample pa
with the glossy side down in the
photo tray.

Tip: If the paper is tabbed, make
sure the tab is towards you.

2 • HP All-in-One

3

6

n

Connect the power cord and adapter

USB cable users: Do not connect the USB cable

until instructed later in this guide.

7

8

Press the On button

After you press the On button, wait for the prompt o

the color graphics display before continuing.

Open the access door

ab

HP All-in-One •

9

h

d

Lift latches inside of the device

a

b

10

a Squeeze the bottom of each latch to release it, an

then lift the latch.

b Lift all six latches.

Insert all six ink cartridges

a

Match the color and pattern of the ink cartridge to th
color and pattern on the print carriage.

a Push the black ink cartridge in to the fi rst slot on t

left. Close the latch.

b Repeat with each of the color ink cartridges.

b

c

c Make sure each latch is secure.

Note: Use only the ink cartridges that came with
the printer. The ink in these cartridges is specially
formulated to mix with the ink in the print head
assembly at fi rst-time setup.

4 • HP All-in-One