Hobart P660 User Manual

P660 MIXERS

ML - 104605

P660 MIXER

EXECUTIVE OFFICES

701 RIDGE AVENUE

TROY, OHIO 45374-0001

FORM 23038 (12-95)

2345678901234567890123456789012123456789

The P660 model mixer is a heavy duty 60 quart mixer which is designed primarily for preparing dough, batter, and pastry. It has a single speed transmission and features a 2 motor, a #12 attachment hub, and an electro-mechanical timer as standard equipment.

A 60 quart stainless steel mixer bowl and a 60 quart burnished aluminum ED style dough arm are furnished with each mixer.

23456789012345678901234567890121234567890123456789012345678901212345678901

Installation, Operation, and Care of

P660 MIXERS

SAVE THESE INSTRUCTIONS

GENERAL

⁄2 horsepower Hobart-built

Bowl Guard is standard equipment on all P660 models.

These mixers can be ordered with deluxe finish, which includes a chrome plated transmission case, base, bowl support, and pedestal.

Shipping Weight: 399 kg (880 lb) Net Weight: 387 kg (853 lb)

Model P660 Mixer

– 2 –

INSTALLATION

UNPACKING

Immediately after unpacking the mixer, check for possible shipping damage. If this machine is found to be damaged after unpacking, save the packaging material and contact the carrier within 15 days of delivery.

Prior to installation, test the electrical service to assure that it agrees with the specifications on the machine data plate.

LOCATION

Place the mixer in its operating location. There should be adequate space around the mixer for the user to operate the controls and install and remove bowls. The area above the mixer should allow the top cover to be removed for routine maintenance and servicing.

Holes are provided in the base for permanent bolting to the floor, although this is not necessary in normal installations. Four plastic plugs are supplied with the mixer to plug these holes if they are not used.

Once located, the mixer must be leveled.

Remove the top cover screws and the top cover.

Place a level on the machined surface of the transmission case (Fig. 1) and slide shims under the legs (base) of the mixer as required to level it front-to-back and side-to-side.

Do not replace the top cover until installation is completed.

Fig. 1

Check Lubrication Before Use

This mixer is shipped with oil in the transmission and planetary. Check oil levels before starting mixer. Refer to

LUBRICATION

, pages 8 – 9, for applicable lubrication procedures.

– 3 –

INSTALLATION CODES AND STANDARDS

The installation of this appliance must be carried out by a licensed installer and in accordance with the applicable regulations, standards, codes of practice and related publications of the country of destination.

ELECTRICAL CONNECTIONS

WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE

APPLICABLE PORTIONS OF RELEVANT ELECTRICAL CODES.

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT.

ELECTRICAL DATA

Model Volts / Hz / Ph Rated Amps

P660 400 / 50 / 3 4

A 26.7 mm hole for installation of electrical conduit is located at the top of the pedestal. Make electrical connections per the wiring diagram located on the inside of the Top Cover.

Check Rotation

Three-phase machines must be connected so the planetary rotates in the direction of the arrow on the Drip Cup. To check rotation:

Set the gear shift lever on 1.

Apply power to the mixer and set the Electro-Mechanical Timer on HOLD. With the Bowl Support all the way up, momentarily run the machine by pushing the START and then STOP buttons.

If rotation is incorrect, DISCONNECT ELECTRICAL POWER SUPPLY and interchange any two of the incoming power supply leads.

– 4 –

+ 8 hidden pages

Hobart P660 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual

GENERAL

INSTALLATION