Card Enrollment Station
User Manual
UD05870B
Card Enrollment Station·User Manual
User Manual
© 2017 Hangzhou Hikvision Digital Technology Co., Ltd.
This manual is applied for D8E series card enrollment station.
It includes instructions on how to use the Product. The software
embodied in the Product is governed by the user license
agreement covering that Product.
About this Manual
This Manual is subject to domestic and international copyright
protection. Hangzhou Hikvision Digital Technology Co., Ltd.
(“Hikvision”) reserves all rights to this manual. This manual cannot
be reproduced, changed, translated, or distributed, partially or
wholly, by any means, without the prior written permission of
Hikvision.
Trademarks
and other Hikvision marks are the property of
Hikvision and are registered trademarks or the subject of
applications for the same by Hikvision and/or its affiliates. Other
trademarks mentioned in this manual are the properties of their
respective owners. No right of license is given to use such
trademarks without express permission.
Disclaimer
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW,
HIKVISION MAKES NO WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
REGARDING THIS MANUAL. HIKVISION DOES NOT WARRANT,
GUARANTEE, OR MAKE ANY REPRESENTATIONS REGARDING THE
USE OF THE MANUAL, OR THE CORRECTNESS, ACCURACY, OR
RELIABILITY OF INFORMATION CONTAINED HEREIN. YOUR USE OF
i
Card Enrollment Station·User Manual
THIS MANUAL AND ANY RELIANCE ON THIS MANUAL SHALL BE
WHOLLY AT YOUR OWN RISK AND RESPONSIBILITY.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN
NO EVENT WILL HIKVISION, ITS DIRECTORS, OFFICERS, EMPLOYEES,
OR AGENTS BE LIABLE TO YOU FOR ANY SPECIAL,
CONSEQUENTIAL, INCIDENTAL, OR INDIRECT DAMAGES,
INCLUDING, AMONG OTHERS, DAMAGES FOR LOSS OF BUSINESS
PROFITS, BUSINESS INTERRUPTION, SECURITY BREACHES, OR LOSS
OF DATA OR DOCUMENTATION, IN CONNECTION WITH THE USE
OF OR RELIANCE ON THIS MANUAL, EVEN IF HIKVISION HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF LIABILITY OR CERTAIN DAMAGES, SO SOME OR ALL
OF THE ABOVE EXCLUSIONS OR LIMITATIONS MAY NOT APPLY TO
YOU.
Support
Should you have any questions, please do not hesitate to contact
your local dealer.
ii
Card Enrollment Station·User Manual
Regulatory Information
FCC Information
Please take attention that changes or modification not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
FCC compliance: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
EU Conformity Statement
This product and - if applicable - the supplied
accessories too are marked with "CE" and comply
therefore with the applicable harmonized European
standards listed under the EMC Directive 2014/30/EU, the RoHS
Directive 2011/65/EU.
iii
Warnings Follow
these safeguards to
prevent serious injury
or death.
Cautions Follow these
precautions to prevent
potential injury or
material damage.
Card Enrollment Station·User Manual
2012/19/EU (WEEE directive): Products marked with
this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or
dispose of it at designated collection points. For more
information see: www.recyclethis.info.
2006/66/EC (battery directive): This product contains
a battery that cannot be disposed of as unsorted
municipal waste in the European Union. See the
product documentation for specific battery
information. The battery is marked with this symbol,
which may include lettering to indicate cadmium (Cd), lead (Pb),
or mercury (Hg). For proper recycling, return the battery to your
supplier or to a designated collection point. For more information
see: www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A) standards
requirements.
Safety Instruction
These instructions are intended to ensure that user can use the
product correctly to avoid danger or property loss.
The precaution measure is divided into Warnings and Cautions:
Warnings: Neglecting any of the warnings may cause serious
injury or death.
Cautions: Neglecting any of the cautions may cause injury or
equipment damage.
iv
Card Enrollment Station·User Manual
Warnings
All the electronic operation should be strictly compliance with
the electrical safety regulations, fire prevention regulations and
other related regulations in your local region.
Please use the power adapter, which is provided by normal
company. The power consumption cannot be less than the
required value.
Do not connect several devices to one power adapter as
adapter overload may cause over-heat or fire hazard.
Please make sure that the power has been disconnected before
you wire, install or dismantle the device.
When the product is installed on wall or ceiling, the device shall
be firmly fixed.
If smoke, odors or noise rise from the device, turn off the
power at once and unplug the power cable, and then please
contact the service center.
If the product does not work properly, please contact your
dealer or the nearest service center. Never attempt to
disassemble the device yourself. (We shall not assume any
responsibility for problems caused by unauthorized repair or
maintenance.)
Cautions
Do not drop the device or subject it to physical shock, and do
not expose it to high electromagnetism radiation. Avoid the
equipment installation on vibrations surface or places subject to
shock (ignorance can cause equipment damage).
Do not place the device in extremely hot (refer to the
specification of the device for the detailed operating
temperature), cold, dusty or damp locations, and do not expose
it to high electromagnetic radiation. The appropriate
temperature is -20℃ to 65℃.
The device cover for indoor use shall be kept from rain and
moisture.
v
Card Enrollment Station·User Manual
Exposing the equipment to direct sun light, low ventilation or
heat source such as heater or radiator is forbidden (ignorance
can cause fire danger).
Do not aim the device at the sun or extra bright places. A
blooming or smear may occur otherwise (which is not a
malfunction however), and affecting the endurance of sensor at
the same time.
Please use the provided glove when open up the device cover,
avoid direct contact with the device cover, because the acidic
sweat of the fingers may erode the surface coating of the device
cover.
Please use a soft and dry cloth when clean inside and outside
surfaces of the device cover, do not use alkaline detergents.
Please keep all wrappers after unpack them for future use. In
case of any failure occurred, you need to return the device to
the factory with the original wrapper. Transportation without
the original wrapper may result in damage on the device and
lead to additional costs.
Improper use or replacement of the battery may result in
hazard of explosion. Replace with the same or equivalent type
only. Dispose of used batteries according to the instructions
provided by the battery manufacturer.
If the device is placed on metal surface, please bolster it
steadily at least 5mm from the surface with insulator.
vi
Card Enrollment Station·User Manual
Table of Contents
1 Overview ...................................................................................................... 1
1.1 Introduction ........................................................................... 1
1.2 Main Features ........................................................................ 2
1.3 Appearance ............................................................................ 2
2 Connection Description ................................................................................ 3
2.1 USB Interface Connection ...................................................... 3
2.2 Communication ...................................................................... 4
vii
D8E Series Card Enrollment Station
Figure 1-1
The picture is only for reference. Please refer to the actual
products.
D8E is a non-touch IC card enrollment station, used as a
necessary non-touch card test machine by card issuers,
chip suppliers, and testing organizations. The 100-D8E card
enrollment station supports PSAM card. The size of the
PSAM cassette equals to that of two SIM cards. The card
enrollment station can connect to PC or other devices via
USB interface. No-driver USB is applied to facilitate the
installation and operation of the card enrollment station.
It is a front-end device which is necessary for developing IC
card-related products or integrating system. With a wide
variety of well-defined APIs (Application Programming
Interface), the card enrollment station can widely applied
in various industries and situations, such as business,
telecommunication, post, insurance, medical treatment,
bank, gasoline station, parking lot, and so on.
Card Enrollment Station·User Manual
1 Overview
1.1 Introduction
1
Card Enrollment Station·User Manual
1.2 Main Features
Plug-and-play USB with no-driver technology
2 PSAM cassettes (Only supported by 100-D8E card
enrollment station)
Supports various card types:
100-D8E Card Enrollment Station: Mifare1 card (Serial No.
and content), CPU (Serial No. and content), and EM card
(Serial No.)
180-D8E Card Enrollment Station: Mifare1 card (Serial No.
and content), CPU (Serial No.), and EM card (Serial No.)
Well-defined API
Adopts high-level encryption algorithm to ensure the security
for data communication
Provides general interface library supporting various
operation systems and language development platform
Supports USB upgrade
Auto-adapt with PSAM card of multiple baud rate(Only
supported by 100-D8E card enrollment station)
1.3 Appearance
Front Panel of Card Enrollment Station Figure 1-2
2
100-D8E Card Enrollment
Station Rear Panel
180-D8E Card Enrollment
Station Rear Panel
Card Enrollment Station·User Manual
Rear Panel of Card Enrollment Station Figure 1-3
The picture is only for reference. Please refer to the actual
products.
2 Connection Description
2.1 USB Interface Connection
Plug the wiring of USB into the USB interface of PC directly.
USB Interface Connection Figure 2-1
3
Card Enrollment Station·User Manual
The picture is only for reference. Please refer to the actual
products.
2.2 Communication
When the card enrollment station is identified by the PC, its
indicator will turn blue, and item “HID-compliant device” or “USB
Input Device” will display in the computer control panel of PC.
Computer Control Panel Figure 2-2
4
Loading...