FingerTec TA100C Installation Guide
Installation Guide
Step 1
Determine the Location and Positioning
of the Installation
Avoid installing the terminals in locations that has contact with
•
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
B. FLEXI KIT
FingerTec offers flexi-kit for all its time attendance models. Attach
the terminal on the flexi-kit for convenience.
TA100C Series
Fingerprint Color Multimedia for
Time Attendance System
© 2014 Timetec Computing Sdn Bhd. A ll rights reserved.• 092014
• Avoid installing the terminals in locations with high moisture or
condensation levels in the air
• The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting of Terminals
A. MOUNT ON WALL
Back Plate
4 feet / 1.2 meter
(recommended)
• After determining the height of the terminal from the ground level
and have made the relevant marks on the wall, drill the screws into
the wall to secure the back plate.
• Attach the terminal to the back plate and tighten the screws. Refer
to Appendix I for dimensions and measurements of installation.
Step 3
Wiring for Power Supply
The power jack is positioned on top of the terminal, labeled
Power Adapter Port in the below diagram.
R
e
s
e
t
......
........
TCP/IP PORT
POWER PORT
USB PORT
Please use the power adaptor provided in the package or alternatively you can opt for a linear power supply with specifications of
5VDC 2A. Plug the one point of the power adapter to the terminal
and the other end to the power outlet. Don’t exceed the recommended voltage or current to avoid damaging the terminal.
Step 4
Setting Up Data Communications
(Skip this step if you are using USB ash disk to transfer data)
TCP/IP – LAN Connection
For TCP/IP connection, plug the special RJ45 jack into the TCP/IP
(LAN) Port of the terminal. Connect the other end (normal RJ45
jack) to the local area network hub or a PC. Configure the device ID,
IP address, subnet mask and Gateway in the terminal (refer to the
hardware user manual for details).
Step 5
Finalizing the installation
1. Check that all cable connections are done correctly.
2. Attach the terminal to the corresponding back plates, tighten
the screws to secure the terminal on the wall
3. Switch on the power to the terminal.
4. Start using the terminal.
Other Accessories
Appendix I
Terminal Dimensions and Measurements
AdapTec TA
R
O
L
O
O
C
K
D
T
I
M
E
R
Note:
All Accessories are offered at
http://accessory.fingertec.com
The AdapTec TA is a 5VDC power supply inclusive of a 110~240VAC
switching linear power. The AdapTec provides 5VDC power to the FingerTec terminal and charges a 12VDC 7.0Ah backup battery simultaneously. During an event of a power failure, the back up battery will
automatically provides power to the terminal.
Mini UPS
Mini UPS 5VDC is a mini portable backup power
supply with 5VDC output, supplying 5VDC power
for FingerTec Time Attendance terminals.
Enclosures
FingerTec offers enclosures to protect the terminals from being meddled with by unauthorized persons.
Flexi Kit
A foldable stand for FingerTec products, simplifies installation and
presentable. (Example on Step 2, B.)
Front View of TA100C Series
Loading...