Epson WF-4720 User Manual

WF-3720/WF-4720/WF-4730/WF-4740 Series

2

Turn on and configure

Start Here

Read these instructions before using your product.

The illustrations show the WF-4740, but the steps are the same
for all models, unless otherwise specified.

Note for Spanish speakers/Nota para hispanohablantes:

Para obtener instrucciones de configuración en español, visite la página
de soporte de su producto en www.epson.com/support (EE.UU.) o
www.epson.ca/support (Canadá) y consulte la Guía de instalación
(requiere una conexión a Internet).

1

Unpack

1 Connect the power cord to the back of the product and to

an electrical outlet.

Caution: Do not connect to your computer yet.

2 Raise the control panel and turn on the product.

3 Select your language, country, and time.

Note: You can change these settings later using the product’s

control panel. For more information, see the online User’s Guide.

Note: Do not open the ink cartridge packages until you are ready to

install the ink. Cartridges are vacuum packed to maintain reliability.

1 Remove all protective materials from the product.

2 Lift up the scanner unit until it locks and remove all

protective materials from inside the product.

3

Install ink cartridges

Caution: Keep the ink cartridges out the reach of children and do not

drink the ink.

1 Lift up the scanner unit until it locks.

Caution: Do not touch the flat, white cable.

2 Gently shake the ink cartridges.

3 Lower the scanner unit.

3 Unpack the ink cartridges.

4 Remove only the yellow tape from each ink cartridge.

WF-3720:

Caution: Do not remove any other labels or seals, or ink will leak.

Do not touch the green chip on the cartridge.

WF-4720/WF-4730/WF-4740:

Caution: Do not remove any other labels or seals, or ink will leak.

Do not touch the green chip on the cartridge.

4

Load paper

1 Make sure the product is done charging the ink, and then

close the control panel, lift the output tray, and pull out the
paper cassette.

2 Slide the side edge guides all the way out and set the

front edge guide to the paper size you are using.

5 Insert the cartridge in the holder for each color. Press each

cartridge down until it clicks. Make sure all cartridges are
pushed down into place.

6 Lower the scanner unit.

7 If prompted, follow the instructions on the LCD screen.

The printer starts charging the ink. Ink charging takes
approximately 5 minutes. When you see a completion
message on the printer’s LCD screen, charging is
complete.

3 Insert paper with the glossy or printable side down.

Note: Make sure the paper is loaded against the front edge guide

and not sticking out from the end of the cassette.

4 Slide the edge guides against the paper, but not too

tightly.

5 Keep the cassette flat as you insert it all the way, then

lower the output tray.

Caution: Don’t turn off the printer or raise the scanner unit while

the printer is charging or you’ll waste ink.

Note:

• The printer is designed for use with Epson® cartridges only, not
third-party cartridges or ink.

• The cartridges included with the printer are designed for
printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.

• WF-4720/WF-4730/WF-4740 Series: Included initial
cartridges print about 500 pages black/450 color.