D-Link DGE-503T User Manual

DGE-530T

Gigabit Ethernet 10/100/1000 Ada

Introduction

This quick Installation guide gives step-by-step instructions for setting up the D-Link DGE –

530T 10/100/1000 PCI Adapter. With auto-negotiation this card can run at three different

speeds: 10/100 Mbps, both half and full duplex, and 1000 Mbps at full duplex. When running

at 1000 Mbps, it provides a throughput of 2 Gbps in Full duplex mode. For more detailed

information on the Adapter, its specifications and making changes to the network, see the

User’s Guide that is included with your adapter.

Check Your Package Contents

If any of these items is missing, please contact your reseller.

DGE-530T Gigabit Ethernet 10/100/1000 Adapter

CD-ROM (containing User Manual)

Quick Installation Guide

Software and specifications subject to change without notice.

Hardware Installation

Before you start, make sure to turn off your computer and unplug the power cord.

Note: To avoid damage caused by static electricity, make sure to properly ground yourself by first touching a metal part of your computer to discharge any static electricity before working with the DFE-530T Ethernet Adapter.

1. Shut down the computer and unplug the power cord.

2. Remove the chassis cover.

3. Insert the card into the empty PCI slot.

4. Replace the computer chassis cover.

5. Reconnect the power cord and turn the computer on. Is the BIOS section of your

computer is plug and play compliant, then at the power up the BIOS will automatically

configure any newly installed DGE-530T Adapter.

Installing the DGE-530T Driver

1. Turn on the computer.

2. Insert the driver CD included with the DGE-530T into the CD ROM.

3. The screen shown below will appear automatically. Click Install Driver and follow the

instructions on the installation wizard.

+ 2 hidden pages