ELECTRIC OIL-FILLED RADIATORS
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
LOS RADIADORES ELÉCTRICOS DE ACEITE
INSTRUCIONES IMPORTANTES
REPASE Y GUARDE ESTAS INSTRUCCIONES
LEA CUIDADOSAMENTE ESTE INSTRUCTIVO ANTES
DE USAR SU APARATO
LES RADIATEURS À BAIN D’HUILE
MODE D’EMPLOI IMPORTANT
CONSERVEZ CE MODE D’EMPLOI
Model/Modelo/Modèle
TRD0715T
Register this product online and receive a free trial issue of Cook's Illustrated. Visit www.delonghiregistration.com
Visit www.delonghi.com for a list of service centres near you.
Registre este producto en línea y reciba un ejemplar gratis de Cook's Illustrated. Visite www.delonghiregistration.com
Visite www.delonghi.com para ver la lista de centros de servicios cercanos a usted.
Enregistrez ce produit en ligne et recevez un numéro gratuit de Cook's Illustrated. Visitez www.delonghiregistration.com
Visitez www.delonghi.com pour y voir une liste des centres de réparation proches de chez vous.
ELECTRIC CHARACTERISTICS/ CARACTERISTICAS ELECTRICAS/
CARACTÉRISTIQUES ÉLECTRIQUES
120 V~ 60 Hz 1 500 W
EN
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be taken to avoid the risk of fire, electric shock and personal injury, including the following:
1.Read all instructions before using this heater.
2.If your radiator is equipped with a polyethylene tape used as a carry handle, remove it before connecting appliance to the outlet.
3.This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handle when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 90 cm (3 ft.) from the front and top of the heater and keep them away from the sides and rear.
4.Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
5.Always unplug heater when not in use.
6.Check that neither the appliance nor the power cable have been damaged in any way during transportation.
7.Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. If heater has leaked any oil, discontinue using the heater and contact the service centre as indicated in the instruction leaflet. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
8.Do not use outdoors. Household use only.
9.This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
10.Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
11.To disconnect heater, turn controls to off, then remove plug from outlet.
12.Connect to properly polarized outlets only.
13.Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the heater.
14.To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
15.A heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored.
16.Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
17.To prevent overload and blown fuses, be sure that no other appliance is plugged into the same outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
18.It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord which becomes hot to the touch or becomes distorted in shape may be the result of a worn electrical outlet.
Worn outlets or receptacles should be replaced prior to further use of the heater. Plugging heater into a worn outlet /receptacle may result in overheating of the power cord or fire.
19.Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
20.Be sure that the plug is fully inserted into an appropriate outlet. Please remember that outlets also deteriorate due to aging and continuous use: check periodically if signs of overheating or deformations are evidenced by the plug. Do not use the outlet and CALL your electrician.
21.Make sure that no pieces of polystyrene or other packaging material have been left between one element of the appliance and another. It may be necessary to pass over the appliance with a vacuum cleaner.
2
Loading...