Canon ip4200 CISS User Manual

Instruction for Canon Pixma ip4200 CISS

I CISS Components:

1) CISS 1 set 2) air filter 5 pcs 3) support arm 1 set

4) Syringe 5 pcs 5) CD instruction 1 pc

II How to Install:

Step 1:

1.Put the CISS at the right side of 2. Pull out the rubber plug from 3. Insert the Air Filter.

the printer the Air Hole.

Step 2: Install Chips

1.Take out the original cartridge, 2.Use knife to cut the 2 points 3. Then the chip is removed.

and find the chip. that fix the chip. And then

remove the chip. Pls be careful

when doing this.

4.Put glue at the same position 5.Stick the chips on the CISS 6. Repeat this with other
of the CISS cartridge (at the cartridge (Pls note that the cartridges.

2 sides) color should be correct. Do
Not misuse the chips).

Step 3: Install Cartridges

1.Fix the support arm on the printer. 2. Put the cartridges in the printer carriage.

Step 4: Fix the Tube

1. Fix the tube on the support arm 2. The installation is finished.
with the tube clip.

Step 5: Adjust the Tube

1. Adjust the length of the tube, 2.Leave enough length for the 3. Make sure that the rube will not

and move the printer carriage. tube so that the carriage can make trouble to the carriage

reach the fastest place. moving during working.