Campbell Hausfeld RP4000, IN239502AV, RP4100 User Manual

1.23 Mb
Loading...

See Warranty on page 3 for important information about commercial use of this product.

Operating Instructions

RP4000, RP4100

 

 

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.

120-Volt Inflators

Description

The 120-volt inflator comes with inflation nozzles and needle. The inflator can be used for inflating car and bike tires, soccer balls, beach balls and other sporting equipment.

Unpacking

When unpacking this product, carefully inspect for any damage that may have occurred during transit.

Safety Guidelines

This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help

recognize this information, observe the following symbols.

Danger indicates an imminently

hazardous situation which, if not avoided, WILL result in death or serious injury.

Warning indicates a potentially

hazardous situation which, if not avoided, COULD result in death or serious injury.

Caution indicates a potentially

hazardous situation which, if not avoided, MAY result in minor or moderate injury.

Notice indicates important

information, that if not followed, may cause damage to equipment.

General Safety

Completely read the manual included with this product carefully. Be thoroughly MANUAL familiar with the proper use

of the unit.

Any misuse of unit could cause property or equipment damage and/ or personal injury.

California proposition 65

This product or

its power cord may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.

Do not leave the

inflator unattended while the unit is running.

Unit must be securely and

adequately grounded. See grounding instructions and extension cord information in this manual.

Never exceed the recommend-ed pressure for

any inflatable object. Do not

over inflate objects. Over inflation could cause property damage and/or personal injury.

The universal adapter must

be locked to secure the inflation accessories. Use extreme caution when using inflation accessories.

Always use a separate pressure

gauge to check the actual pressure in tires and in low pressure inflatable objects.

Inflator must cool for 20 minutes after

20 minutes of continuous oper-ation. The Inflator is not designed to operate continuously for more than 20 minutes.

Do not use inflator on high pressure

tires used on large trucks, trailers or tractors. The inflator is not designed to operate for the length of time necessary to inflate these tires.

Make sure the universal adapter

touches the core or tire valve stem.

Preparation

Grounding Instructions

1.This product must be grounded. In the event of an electrical short circuit, grounding reduces risk of electrical shock by providing an

escape wire for electric current. This product is equipped with a cord having a grounding wire with an appropriate grounding plug. Plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.

Grounding

 

Grounded

Pin

TEST RESET

Outlet

Figure 1 - Grounding Method

Improper use of grounding plug can result in a possible risk of electrical shock!

NOTE: Do not use grounding adapter.

2.If repair or replacement of cord or plug is necessary, do not connect grounding wire to either flat blade terminal. The grounding wire has insulation and an outer surface that is green with or without yellow stripes.

3.Check with a qualified electrician or serviceman to ensure product is properly grounded. Do not modify plug provided; if plug will not fit outlet, have proper outlet installed by a qualified electrician.

REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.

© 2009 Campbell Hausfeld/Scott Fetzer

For parts, product & service information

IN239502AV 1/10

 

visit www.chpower.com

 

Operating Instructions

Preparation (Continued)

Never connect green (or green and yellow)

wire to a live terminal.

Extension cords

1.Use only a 3-wire extension cord that has a 3-blade grounding plug, and a 3-slot receptacle that will accept plug on product.

2.Make sure extension cord is in good condition, and heavy enough to carry the current the product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating.

3.The chart on page 2 shows correct size to use depending on cord length. If in doubt, use next heavier gauge.

NOTE: The smaller the gauge number, the heavier the cord.

Operation

Tires

1a. Remove valve stem cap.

b.Attach the universal adapter from the inflator to the valve stem with the lever in the up position .

c.Be sure to press universal adapter down over valve stem threads completely.

Recommended Extension Cords

Length of Cord (ft)

25

50

100

150

Gauge of Cord

18

18

16

14

d.When universal adapter is firmly in place, press locking lever down to lock onto valve stem (See Fig. 2).

Universal

Adapter

Lock

Valve Stem

Figure 2

2.Turn the inflator on.

3.When tire is at the desired pressure, turn the inflator off.

4.Check the tire pressure using a separate gauge.

INFLATABLES

1.To use the inflation accessories, snap either piece into the universal adapter and push the lever to lock into place. The inflation accessory will fit securely.

2.Insert the appropriate inflation accessory into the inflatable object

(tire, football, raft, etc.) and turn on the inflator.

3.When the object is firm, switch the inflator off. Do not over inflate objects.

FUSE REPLACEMENT

When replacing the fuse, make sure the inflator is turned off and nothing is connected to the inflator.

1.Unscrew the top of fuse holder.

2.Replace with a new 2-amp fuse. Always replace a blown fuse with the same size fuse.

3.Screw the top of fuse holder back on to the unit.

Maintenance

1.This product has no user serviceable parts and does not require lubrication.

2.Do not store outdoors. When not in use, store in a cool dry place.

Technical Service

For information regarding the operation or repair of this product, please call 1-800-543-6400.

www.chpower.com

2

Operating Instructions

Limited Warranty

1.DURATION: From the date of purchase by the original purchaser as follows: One Year.

2.WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030, Telephone: (800) 543-6400

3.WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of resale) of the Campbell Hausfeld product.

4.WHAT PRODUCTS ARE COVERED BY THIS WARRANTY: This Campbell Hausfeld inflator.

5.WHAT IS COVERED UNDER THIS WARRANTY: Substantial defects in material and workmanship which occur within the duration of the warranty period with the exceptions below.

6.WHAT IS NOT COVERED UNDER THIS WARRANTY:

A.Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED FROM THE DATE OF ORIGINAL PURCHASE AS STATED IN THE DURATION. If this product is used for commercial, industrial or rental purposes, the warranty will apply for ninety (90) days from the date of purchase. Some States do not allow limitation on how long an implied warranty lasts, so the above limitations may not apply to you.

B.ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE, OR MALFUNCTION OF THE CAMPBELL HAUSFELD PRODUCT. Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

C.Any failure that results from an accident, purchaser’s abuse, neglect or failure to operate products in accordance with instructions provided in the owner’s manual(s) supplied with product. Accident, purchaser's abuse, neglect or failure to operate products in accordance with instructions shall also include the removal or alteration of any safety devices. If such safety devices are removed or altered, this warranty is void.

D.Normal adjustments which are explained in the owner’s manual(s) provided with the product.

E.Items or service that are normally required to maintain the product.

7.RESPONSIBILITIES OF WARRANTOR UNDER THIS WARRANTY: Repair or replace, at Warrantor’s option, products or components which are defective, have malfunctioned and/or failed to conform within the duration of the specific warranty period.

8.RESPONSIBILITIES OF PURCHASER UNDER THIS WARRANTY:

A.Provide dated proof of purchase and maintenance records.

B.Call Campbell Hausfeld (800) 543-6400 to obtain your warranty service options. Freight costs must be borne by the purchaser.

C.Use reasonable care in the operation and maintenance of the products as described in the owner’s manual(s).

9.WHEN WARRANTOR WILL PERFORM REPAIR OR REPLACEMENT UNDER THIS WARRANTY: Repair or replacement will be scheduled and serviced according to the normal work flow at the servicing location, and depending on the availability of replacement parts.

This Limited Warranty applies in the United States, Canada and Mexico only and gives you specific legal rights. You may also have other rights which vary from state to state or country to country.

www.chpower.com

3

+ 5 hidden pages