Bosch D7050-B6 Installation Manual

D7050-B6

Installation Instructions

Smoke Detector Base

D7050-B6 | Installation Instructions |

1.0 Overview

The D7050-B6 Smoke Detector Base is used with the D7050 Series Photoelectric Smoke Detectors. Install the D7050-B6 according to NFPA 72.

Before installing the D7050-B6, read and become familiar with these instructions and the following documents to ensure proper system operation:

• D7050 Series Photoelectric Smoke Detectors Installation Instructions (P/N: 47458)

• NFPA Standard 72 only contains the information necessary to mount and wire the base. More information is provided in the:

Smoke Detector Technical Service Note (P/N:

26715)

- D7050 Series Installation Instructions (P/N:

47458) for information on power requirements, testing, and maintenance

for installation guidelines.

2.0 Mounting

1. Select the mounting location according to the

installation guidelines in the Smoke Detector Technical Service Note (P/N: 26715).

2. Pre-run all system wiring.

3. Mount the D7050-B6 using the two oblong

mounting holes.

4. Tighten the D7050-B6 to the mounting surface

using six 32 in. x 1 in. (81 cm x 2 cm) mounting screws (not provided).

If mounting the D7050-B6 to a 4 in. (10.2 cm) square box, use the adapter plate and:

a. mount the adapter plate to the box,

b. then, mount the D7050-B6 to the adapter

plate and box using two of the oblong mounting holes.

Depending on the local regulations, you can mount the D7050-B6 using anchors, mollies, or wing nuts. You can also mount it directly to the 4 in. (10.2 cm) octagonal electrical box and single-gang switch box (Figure 1).

Figure 1: Mounting the D7050-B6

1 - Use these holes to mount the D7050-B6 to the adapter plate.

2 - Use these holes to mount the D7050-B6 to the octagon box.

3 - Use these holes to mount the D7050-B6 to the adapter plate. Use self-threading 6-32 x 1 in. screws (not supplied).

Use electrical boxes that can accommodate the numbers and sizes of conductors specified by the National Electrical Code (NEC) or the local Authority Having Jurisdiction (AHJ).

5. Review the wiring information in Section 3.0 Wiring on page 3.

6. Connect the wiring to the D7050-B6.

Bosch Security Systems, Inc. | 08/07 | F01U063155-012

+ 2 hidden pages