Behringer 173 Quick Start Guide

Quick Start Guide
173 QUAD GATE/MULTIPLES
Legendary Analog Quad Gate & Multiples Module for Eurorack
Controls
(1) (2)
(3)
(4)
(1) GATE OUT – Send th e gate signal to another m odule via
3.5 mm TS cabl e.
(2 ) GAT E IN – Connec t an incoming signa l via
3.5 mm TS cabl e.
modules to control gate operation, non-inverting (active hig h) and inverting (acti ve low) inputs.
(4 ) MULTIPLES – Connec t a signal to the A jack tha t will be
sent to mult iple designation s via the B, C and D jacks in the same ro w.
Power Connection
The module c omes with the requ ired power cable f or connecting to a standa rd Eurorack power su pply system. Fol low these steps to con nect power to the mo dule. It is easier to make these con nections bef ore the module has be en mounted into a rack cas e.
1. Turn the power su pply or rack case p ower o and disconne ct the power cabl e.
2. Insert the 16- pin connector o n the power cable into t he socket on t he power supply or rac k case. The connec tor has a tab that wi ll align with the gap in t he socket, so it can not be inser ted incorrec tly. If the power supply d oes not have a keyed socke t, be sure to orient pi n 1 (-12 V) with the red stripe o n the cable.
3. Insert the 10 -pin connecto r into the socket on th e back of the module. T he connector has a t ab that will align wi th the socket fo r correct ori entation.
4. After both en ds of the power cable hav e been securely attac hed, you may mount the mo dule in a case and tur n on the power supply.
Installation
The neces sary screws ar e included with th e module for mount ing in a Eurorac k case. Connect t he power cable bef ore mounting.
Dependi ng on the rack case, th ere may be a series of x ed holes spaced 2 HP ap art along the leng th of the case, or a tra ck that allows indi vidual threaded p lates to slide along th e length of the cas e. The free-movi ng threaded plate s allow precise positio ning of the module, bu t each plate should be po sitioned in the approx imate relation to th e mounting holes in yo ur module before a ttaching the sc rews.
Hold the mo dule against the Eur orack rails so that e ach of the mounting h oles are aligned wi th a threaded rail o r threaded plate. Att ach the screws par t way to start, w hich will allow small adjus tments to the pos itioning while you g et them all aligned. After the nal position has been established, tighten the screws d own.
Specications
Signal Input
Type 3.5 mm jack, DC coupled
Impedance 160 kΩ, unbalanced
Maximum input level +17 dBu
Signal Output
Type 3.5 mm jack, DC coupled
Impedance 1 kΩ, unbalanced
Maximum output level +17 dBu
Frequency response DC to 20 kHz
Output noise <-90 dBu, 22 Hz - 22 kHz
Gate Control
Type
Impedance >50 kΩ, unbalanced
Switching threshold
Maximum input level 10 V p-p
Multiples
Type
Arrangement
Compatibility CV and audio signals
Power
Power supply Eurorack
Current draw
Physical
Dimensions
Rack units 16 HP
Weight 0.18 kg (0.4 lbs)
2 x 3.5 mm jacks, non-inverting and inverting
Non inverting > +3 V, inverting < +1.5 V
24 x 3.5 mm TS mono jacks, unbalanced
6 sets of 4 parallel jacks, passive
40 mA (+12 V), 40 mA (-12 V)
28 x 81 x 129 mm (1.1 x 3.2 x 5.1")
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be suered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Auratone and Coolaudio are trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2019 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding Music Tribe’s Limited Warranty, please see complete details online at musictribe.com/warranty.
Zhongshan Eurotec Electronics Limited
No. 10 Wanmei Road, South China Modern Chinese Medicine Park, Nanlang Town, 528451, Zhongshan City, Guangdong Province, China
Loading...