Apple A2056, A2002, A1923, A2055 User Manual

Charging

Charger attaches
magnetically to the
back of the case.

FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.

Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.

This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and
receiver.

•

Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician
for help.

Important: Changes or modifications to this product not
authorized by Apple could void the electromagnetic

compatibility (EMC) and wireless compliance and negate your
authority to operate the product.

This product has demonstrated EMC compliance under
conditions that included the use of compliant peripheral
devices and shielded cables between system components. It
is important that you use compliant peripheral devices and
shielded cables between system components to reduce the
possibility of causing interference to radios, televisions, and
other electronic devices.

Responsible party (contact for FCC matters only):
Apple Inc.!
One Apple Park Way, MS 911-2HW!
Cupertino, CA 95014
www.apple.com/contact

Canadian Compliance Statement

This device complies with Innovation, Science and Economic
Development Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.

Le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil!
ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.

CAN ICES-3 (B)/NMB-3(B)

Exposure to radio frequency energy

The radiated output power of this device meets the limits of
FCC/IC radio frequency exposure limits. This device should be
operated with a minimum separation distance of 20cm (8
inches) between the equipment and a person's body.

Le present appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit
accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le
fonctionnement.

Certification and Compliance

Australia
New Zealand

U.S.

Japan

Korea

R-RMI-APL-A1923

If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician
for help.

Important: Changes or modifications to this product
not authorized by Apple could void the electromagnetic
compatibility (EMC) and wireless compliance and negate
your authority to operate the product.

This product has demonstrated EMC compliance under
conditions that included the use of compliant peripheral
devices and shielded cables between system components.
It is important that you use compliant peripheral devices and