BI10
Introduction
!
RECOGNIZE THIS SYMBOL AS
A SAFETY PRECAUTION
!
CAUTION
To avoid personal injury and property damage,
observe all safety instructions.
!
CAUTION
To avoid property damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective
material.
Read entire manual before installing kit. Confirm all
parts listed are included in kit. If parts are missing,
contact source from whom kit was purchased.
Important
• Mechanical experience is required to install trim kit.
• Depending on installer’s knowledge and skill,
installation can take from one-half to one hour.
• If unable to solve a problem during installation,
contact source from whom kit was purchased.
Parts List
Procedure
!
CAUTION
To avoid personal injury, protect hands and arms.
Trim pieces may have sharp edges.
1. Identify cabinet opening where opening is a
minimum of 69" (1753 mm) high, 24" (610 mm)
deep and 36" (914 mm) wide. Front corners of
counter top may need to be trimmed at a 45° angle
so doors will open completely.
36"
69"
24"
2. Level refrigerator in cabinet opening according to
instructions in Owner's Manual. Roll refrigerator out
of opening to install kit.
3. Slide a L-shaped bezel gusset into end of left and
right frame. Insert screws and tighten.
Item Description Qty
1 L-shaped Bezel Gusset 2
2 Bezel Gusset Machine Screw 4
3 Right Cabinet Frame 1
4 Left Cabinet Frame 1
5 Top Cabinet Frame 1
Side-by-Side Refrigerator BI10, BI11, BI12, BI13 Perimeter
Trim Kits Installation Instructions
Loading...