|
IT |
Libretto Istruzioni |
2 |
|
|
|
|
|
GB |
Instruction Manual |
11 |
|
|
|
|
|
FR |
Manuel d’Instructions |
20 |
|
|
|
|
|
|
|
|
|
DE |
Bedienungsanleitung |
29 |
|
|
Gebruiksaanwijzing |
|
|
NL |
38 |
|
|
|
|
|
|
|
|
|
EFC 6510
EFC 9510
Dear Customer,
If you follow the recommendations contained in this Instruction Manual, your appliance will give you constant high performance and will remain efficient for many years to come.
CONTENTS
RECOMMENDATIONS AND SUGGESTIONS |
12 |
CHARACTERISTICS |
13 |
INSTALLATION |
14 |
USE |
17 |
MAINTENANCE |
18 |
GB |
|
11 |
RECOMMENDATIONS AND SUGGESTIONS
INSTALLATION
•The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
•The minimum safety distance between the cooker top and the extractor hood is 650 mm.
•Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood.
•For Class I appliances, check that the domestic power supply
guarantees adequate earthing.
Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible.
•Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc.).
•If the extractor is used in conjunction with non-electrical appliances
(e.g. gas burning appliances), a sufficient degree of aeration must
be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean
air.
650 mm min.
USE
•The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.
•Never use the hood for purposes other than for which it has ben designed.
•Never leave high naked flames under the hood when it is in
operation.
• Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides.
•Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.
•The hood should not be used by children or persons not instructed in its correct use.
MAINTENANCE
•Switch off or unplug the appliance from the mains supply before carrying out any maintenance work.
•Clean and/or replace the Filters after the specified time period.
•Clean the hood using a damp cloth and a neutral liquid detergent.
GB |
|
12 |
CHARACTERISTICS
Dimensions
260
300
62 - 72
598 - 898
Components
55 433
740940 740minmax
545
The described equipment could change according to the different countries.
|
15 |
|
Ref. |
Q.ty |
Product Components |
|
|
1 |
1 |
Hood Body, complete with: Controls, Light, |
|
|
|
14.1 |
|||
|
|
|
|
Blower, Filters |
|
|
|
|
|
|
|
|
|
|
2 |
1 |
Telescopic Chimney comprising: |
16 |
12a |
7.2.1 11 |
2.1 |
1 |
Upper Section |
|
2.2 |
1 |
Lower Section |
||
|
|
|
|||
14 |
|
|
8a |
1 |
Right Air Outlet Grill |
9 |
|
|
8b |
1 |
Left Air Outlet Grill |
|
|
|
9 |
1 |
Reducer Flange ø 150-120 mm |
|
|
|
14 |
1 |
Hood Body Air Outlet Extension Piece consisting |
|
|
|
|
|
of two Half Shells |
2.1 |
|
12c |
14.1 |
2 |
Air Outlet Connection Extension |
|
|
15 |
1 |
Air Outlet Connection |
|
2 |
|
|
|||
|
|
16 |
1 |
Air Outlet Deflector |
|
8b |
|
|
|||
|
8a |
|
|
|
|
|
|
|
|
|
|
2.2 |
|
|
Ref. |
Q.ty |
Installation Components |
|
|
|
|||
|
|
|
7.2.1 |
2 |
Upper Chimney Section Fixing Brackets |
|
|
|
11 |
6 |
Wall Plugs |
|
|
11 |
12a |
6 |
Screws 4,2 x 44,4 |
|
|
12c |
6 |
Screws 2,9 x 9,5 |
|
|
|
12a |
|||
|
|
|
|
|
|
|
|
|
|
Q.ty |
Documentation |
1 |
|
|
|
1 |
Instruction Manual |
GB |
|
13 |