A300EM
207 3450 02
AA 555522 EE AA 330000 EE
OOppeerraattiioonn iinnssttrruuccttiioonnss
page 1
GGeebbrraauucchhssaannlleeiittuunngg
seite 6
GB IE
D AT CH
2
3
IMPORTANT
First make sure that the appliance has not been damaged in transit. If any damage
has been incurred, please inform the supplier immediately.
Please read these instructions carefully.
Keep the instructions in a safe place and make sure that they are retained with the
refrigerator when the appliance is transferred to a new location or owner.
Note! If this refrigerator is replacing a larger one which is going to be scrapped,
remove the door before disposal to prevent children from becoming trapped inside.
Please contact the relevant area refuse office to arrange disposal. The pipe system
of your refrigerator must not be damaged if technically correct disposal is to be
guaranteed.
If possible, please take the packaging of your new refrigerator to the recycling centre
for your area.
Recommendation: before installation or initial use of the appliance, clean the interior
and fittings with lukewarm water and, if necessary, a mild detergent. Never use
acidic, abrasive or strongsmelling detergents or wax polishes!
Connecting to the mains
The refrigerator must only be connected to the electricity supply using an earthed
socket outlet, installed in accordance with local regulations. Before connecting the
refrigerator, check from the data label inside the cabinet that the voltage agrees with
your mains supply.
Plug connection (for United Kingdom only)
If a 3-pin 13 amp fused plug is used, it should be fitted with a 3 amp fuse; with other
plug types, the circuit should contain a 5 amp fuse.
Warning - This Appliance must be earthed.
MOULDED-ON PLUG WITH FUSE (for United Kingdom only)
The mains lead is fitted with a nonrewirable moulded-on 13 amp plug containing a 3
amp fuse. If the fuse requires replacing at any time, the fuse cover/carrier should be
removed using a small screwdriver to lever it out. The old fuse should be replaced
by a 3 amp ASTA approved BS1362 fuse and the fuse cover/carrier must be refitted
before the plug is used again.
If the fuse cover/carrier is lost, a replacement can be obtained from our service
shops. The fuse cover/carrier must be of the same colour as that of the coloured
insert in the base of the plug. In no circumstances must the plug be used without a
correct fuse cover/carrier fitted.
If the plug supplied on the mains lead is not suitable for the socket in your home, it
should be cut off and disposed of safely, or destroyed, to avoid any possible shock
hazard resulting from the plug being inserted into a 13 amp socket elsewhere in the
house. A suitable replacement plug should then be fitted as given below.
Loading...