2N Wireless 3G router 2N EasyRoute_old design - Quick start, 1526 v2.00, EasyRoute 3G Gateway Manual

2N Wireless 3G router 2N EasyRoute_old design - Quick start, 1526 v2.00, EasyRoute 3G Gateway Manual

Incoming Call

1.An incoming call is signalled by ringing. The phone line LED is flashing during ringing.

2.Hook off the phone to establish the call. The phone line LED is permanently on during the call.

3.Hang up the phone to terminate the call.

Internet Setup


1.Make sure that the TCP/IP protocol is installed in your PC and set the PC to getting IP address automatically from the DHCP server. Most operating systems use this setting by default.

2.Open any web browser: Internet Explorer, Mozilla Firefox, Google Chrome, etc.

3.In the address window, write the IP address: to get into the basic login dialogue.

4.Log in as Administrator. Fill in the fields as follows.

User: Admin Password: 2n

For older 2N® EasyRoute versions you have to use:

User: admin , Password: admin

GSM/UMTS setup

Use the Wizard menu to set a quick Internet connection (short form setting). Be sure to confirm any change in the Wizard submenus using the Apply button in the right-hand bottom


5.If you use a PIN protected SIM card, set the PIN in the WIZARD->SIM menu. Then enable the Remember

item to make the gateway use this PIN after restart.

6.Use the WIZARD->Internet menu to set the Internet connection parameters. These parameters are set automatically by most Internet providers. Check the APN [list] for your provider. If your provider is not included, fill in the APN and Dial items using information obtained from your Internet provider. For some providers, it is necessary to fill in the User and Password fields too.

7.Use the WIZARD->Wireless menu to enable the WiFi connection in your local network (Enable). Use encoding to protect your LAN against unauthorised access if necessary. You are suggested to use the WPA or a higher encoding system to get the proper level of protection.

8.Check the current state of the router in the STATUS menu where the most important information is displayed. The Status field displays the Internet status: Connected. Now you can start browsing through the Internet.

9.In this menu you can check such gateway parameters as the connection type, provider, signal strength and some more parameters important for the gateway function.

10.For more advanced settings and rules such as SIP connection, Firewall and many others refer to the CD manual.

11.Use the LOG OUT button in the left bottom corner to leave the configuration interface. Logout is done automatically after 20 minutes of inactivity.

In the GSM network, data transfers are suspended during voice calls and do not continue until the voice call is finished, whereas in the 3G (UMTS) network data and voice are transferred simultaneously.

EC Declaration of Conformity

Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N® EasyRoute product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Refer to the CD-ROM or our website www.2n.cz for the Declaration of conformity.

© 2011, 2N TELEKOMUNIKACE a.s. – Prague, LH 1526, v.2.00

+ 1 hidden pages