USER MANUAL
Master Anamorphic Lens 135/T1.9
Lens Flare Set
Date: May 2015
Version 05/2015
Flare Set User Manual
Intended use
The Master Anamorphic Lens Flare Sets are designed to be used on ARRI/ZEISS
Master Anamorphic lenses. Each Flare Set should only be used on the specified
focal length.
Safety tips
Caution
To ensure proper and safe use, we recommend that you read these safety
and operating instructions before using the product and then store them.
Non-observance can lead to injury or damage.
Safety and handling
Never point the flare elements or the lens directly towards the sun, because
you can significantly damage your eyesight. Store the flare elements into
their boxes when they are not in use. Otherwise they could start a fire!
Storage and transportation
Use the product only in temperatures ranging between -20°C and 40°C.
The product is not water resistant or waterproof, but it is equipped with dust
and weather seals to ensure weather protection when attached to the lens and
used in normal conditions. Protect the camera and lens appropriately when in
rainy or damp environments.
Should the product be exposed to moisture, dismount it from the camera.
Allow the device to dry completely before using it again. Do not attempt to dry
the product with the help of an external heat source, e.g. in a microwave oven
or using a hairdryer.
Delivery
1
Case
2
Front Flare Element
3
Rear Flare Element
4
Screws
5
User Manual
Version 05/2015
Master Anamorphic Lens 135/T1.9
Attention
1. During the assembly ensure that the environment is clean and free from
dust so that no dust particles can enter the lens.
2. To tighten and untighten the screws only use a T4 torque wrench with
a torque of 0.15Nm. If you use the lens in a rough environment please
secure the tightness of the screws afterwards with the T4 torque
wrench (same procedure as with the lug nuts on your car).
3. ZEISS uses locking varnish on the screws. As you remove the screws
from the lens we recommend to throw them away. Otherwise particles
of the dried locking varnish could soil the lens.
4. Only tighten or untighten the screws described in this manual. Otherwise
you will lose performance and warranty.
5. Smudges and fingerprints on the lens surface can be removed with the
ZEISS lens cleaning kit.
6. In case of further questions please contact an ARRI Service Station
(www.arri.de/service) or a ZEISS Cine Service Station
(+49 7364 20- 6175 or www.zeiss.com/cine)
Loading...